Abstract:Due to non-condensable gas under conditions of vacuum and low temperatures, it becomes difficult to obtain precise vapor pressures of typical liquid desiccants by an experiment. Usually, non-condensable gas is removed by a traditional degassing method (degassing after prepared solutions - DPS), in which prepared liquid desiccants are circularly frozen and non-condensable gas is pumped out. However, the solvent of liquid desiccants could greatly evaporate during traditional degassing processes. Concentrations of the prepared liquid desiccants could be greatly deviated from those of the prepared liquid desiccants. Accordingly, measured vapor pressures usually greatly deviate from those corresponding to the concentrations of the prepared liquid desiccants. Moreover, it becomes very difficult to determine new concentrations of the prepared liquid desiccants after degassing, precisely. To overcome the challenges for precise measurements of typical liquid desiccants, a novel technique is developed in this context. The new method is called DSSPS (degassing solvents and solutes before preparing solutions - DSSPS), in which degassed solvent and solute is weighted respectively, and then, is mixed as measured solutions. Thus, concentrations of the measured solutions could be determined easily and precisely. Vapor pressures of LiCl-H2O desiccants are measured by the new method at a range from 218K to 258K and with the mass fractions of solutions from 5% to 20%. Totally, 35 sets of vapor pressure are measured. Then, the data is correlated based on Antoine equation. The ARD% (Absolute Relative Deviation - ARD) of equation is from 0.04% to 3.21% and AARD% (Average Absolute Relative Deviation - AARD) is 1.73%. So, the new method could be used to measure vapor pressure of aqueous solutions at vacuum and low temperatures precisely. The average error between experimental data and the results calculated by EES (Engineering Equation Solver - EES) is within 15.2%, and its maximum error is 35.46%. Vapor pressure data in this context also provides important reference for development of a precise calculation model.

Liquid Density Measurement of N-Decane with a Random Temperature Signal Cross-Correlation Densimeter at High Temperatures and Pressures

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Liquid Densities for N-Decane + P-Xylene Mixtures from 293.15 K to 363.15 K at Pressures Up to 60 MPa

VAPOR PRESSURE MEASUREMNET OF LIQUID DESSICANTS AT LOW TEMPERATURES BY A NOVEL TECHNIQUE

Density and Viscosity Measurements of N-Dodecane and Carbon Dioxide + N-Dodecane at Temperatures from (298 to 548) K

Compressed liquid densities of binary mixtures of n-decane + n-dodecane at temperatures from 283 K to 363 K and pressures up to 100 MPa

Simultaneous measurement of the density and viscosity for n-Decane + CO2 binary mixtures at temperature between (303.15 to 373.15) K and pressures up to 80 MPa

High-pressure Densities of N-Decane+o-xylene Mixtures: Measurement and Modelling

Investigation on Liquid Density Data at the Bubble Point and Equations for the Refrigerant Hfc-404a over A Wide Temperature Range

PρT Measurements and Modelling of (N-Decane + M-Xylene) Mixtures from 293.15 K to 363.15 K at Pressures Up to 60 MPa

Density measurements of endothermic hydrocarbon fuel using random temperature signal cross-correlation

Liquid density of binary mixtures of n -pentane and n -dodecane at temperatures from 283K to 363K and pressures up to 100MPa

Viscosity Measurements of N-Dodecane at Temperatures Between 303 K and 693 K and Pressures Up to 10 MPa

Experimental study on isobaric specific heat capacity of liquid n-decane at subcritical and supercritical pressures

Compressed Liquid Density Measurements of Dimethyl Ether with a Vibrating Tube Densimeter

Density and Viscosity Measurements of 1-Dodecanol and 1,12-Dodecanediol at Temperatures of Up to 573.15 K and Pressures of Up to 10 MPa

Measurement of the Speed of Sound in Near-Critical N-Dodecane at Temperatures from (433 to 679) K and Pressures Up to 10.0 MPa

Measurement of the Speed of Sound in N-Decane at Temperatures from (298.32 to 653.95) K and Pressures Up to 10.0 MPa

Liquid Densities of N-Octane, Ethylcyclohexane and Their Binary Mixtures {(x) N-Octane) + (1 − X) Ethylcyclohexane} at Temperatures from (283 to 363) K and Pressures Up to 60 MPa

Measurement of saturated liquid density of dimethyl ether

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa