Porous Polyurea Supported Pd Catalyst: Easy Preparation, Full Characterization, and High Activity and Reusability in Reduction of Hexavalent Chromium in Aqueous System

Muhammad Sohail Bashir,Xubao Jiang,Xingjie Yang,Xiang Zheng Kong
DOI: https://doi.org/10.1021/acs.iecr.1c01376
2021-05-26
Abstract:Developing efficient supports for transition-metal nanoparticles (M-NPs) to prevent their agglomeration and to facilitate their handling and recycled use has been a constant objective. Herein, porous polyurea (PPU) is prepared by simple precipitation polymerization of toluene diisocyanate through its reaction with water in water–acetone, followed by Pd(OAc)<sub>2</sub> immobilization on a PPU surface to get Pd(OAc)<sub>2</sub>@PPU and by Pd(OAc)<sub>2</sub> reduction to get a hybrid composite with Pd-NPs on a PPU surface. Multiple characterizations revealed that the porous structure of PPU was retained in Pd(OAc)<sub>2</sub>@PPU and Pd NPs were well dispersed on the surface with a mean diameter of 7.18 nm. was used as catalyst for reduction of toxic hexavalent chromium Cr(VI) to benign trivalent chromium with formic acid as the reducer. A higher catalytic performance was detected compared to that of reported heterogeneous catalysts under similar conditions. A slight decrease in catalytic activity was detected in recycled use of the catalyst, which is ascribed to CO poisoning, a byproduct in formic acid decomposition. Full regeneration was obtained by heating the catalyst under N<sub>2</sub> atmosphere for 2 h at 180 °C. This work provides therefore a novel approach for the preparation of a catalyst of high performance for Cr(VI) reduction, featured by low cost, facile synthesis, easy handling, and reusability.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.iecr.1c01376?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.iecr.1c01376</a>.Experimental section; UV–vis absorbance spectra of Pd(OAc)<sub>2</sub> solution, Pd(OAc)<sub>2</sub> loading rate, and Pd(II) loaded on PPU; XRD diffractograms, FTIR and <sup>13</sup>C NMR spectra of PPU, Pd(OAc)<sub>2</sub>@PPU, and ; TEM images of and ; sizes of Pd-NPs in ; UV–vis absorbance of supernatant in Cr(VI) reduction with replaced by Pd(OAc)<sub>2</sub>@PPU, and those in the presence of without FA; UV–vis spectra and pH of K<sub>2</sub>Cr<sub>2</sub>O<sub>7</sub> solution in the presence of different chemicals; reduction of Cr(VI) with different initial concentrations; gas generated by dehydrogenation of FA; chemisorption results of Pd-NPs in and ; reusability of in Cr(VI) reduction; test of Pd leaching from ; XRD diffractograms and TEM images of after six recycled uses and that of the regenerated; UV–vis spectra in Cr(VI) reduction with pretreated with H<sub>2</sub>, CO<sub>2</sub>, and CO; catalytic activity of regenerated at different time.This article has not yet been cited by other publications.
engineering, chemical
What problem does this paper attempt to address?