Abstract:Developing efficient supports for transition-metal nanoparticles (M-NPs) to prevent their agglomeration and to facilitate their handling and recycled use has been a constant objective. Herein, porous polyurea (PPU) is prepared by simple precipitation polymerization of toluene diisocyanate through its reaction with water in water–acetone, followed by Pd(OAc)2 immobilization on a PPU surface to get Pd(OAc)2@PPU and by Pd(OAc)2 reduction to get a hybrid composite with Pd-NPs on a PPU surface. Multiple characterizations revealed that the porous structure of PPU was retained in Pd(OAc)2@PPU and Pd NPs were well dispersed on the surface with a mean diameter of 7.18 nm. was used as catalyst for reduction of toxic hexavalent chromium Cr(VI) to benign trivalent chromium with formic acid as the reducer. A higher catalytic performance was detected compared to that of reported heterogeneous catalysts under similar conditions. A slight decrease in catalytic activity was detected in recycled use of the catalyst, which is ascribed to CO poisoning, a byproduct in formic acid decomposition. Full regeneration was obtained by heating the catalyst under N2 atmosphere for 2 h at 180 °C. This work provides therefore a novel approach for the preparation of a catalyst of high performance for Cr(VI) reduction, featured by low cost, facile synthesis, easy handling, and reusability.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.iecr.1c01376?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.iecr.1c01376</a>.Experimental section; UV–vis absorbance spectra of Pd(OAc)2 solution, Pd(OAc)2 loading rate, and Pd(II) loaded on PPU; XRD diffractograms, FTIR and 13C NMR spectra of PPU, Pd(OAc)2@PPU, and ; TEM images of and ; sizes of Pd-NPs in ; UV–vis absorbance of supernatant in Cr(VI) reduction with replaced by Pd(OAc)2@PPU, and those in the presence of without FA; UV–vis spectra and pH of K2Cr2O7 solution in the presence of different chemicals; reduction of Cr(VI) with different initial concentrations; gas generated by dehydrogenation of FA; chemisorption results of Pd-NPs in and ; reusability of in Cr(VI) reduction; test of Pd leaching from ; XRD diffractograms and TEM images of after six recycled uses and that of the regenerated; UV–vis spectra in Cr(VI) reduction with pretreated with H2, CO2, and CO; catalytic activity of regenerated at different time.This article has not yet been cited by other publications.

Effective catalytic reduction of Cr(VI) over TiO2 nanotube supported Pd catalysts

Liquid Phase Catalytic Hydrogenation Reduction of Cr(VI) Using Highly Stable and Active Pd/CNT Catalysts Coated by N-doped Carbon.

Preparation of Pd/MnO2 catalyst and its catalytic hydrogenation reduction of Cr(VI)

Synthesis of Pd/(MnO2@PANI) Catalyst and Its Study on the Reduction of Cr(VI)

Efficient Photoelectrocatalytic Reduction of Cr(VI) Using TiO2 Nanotube Arrays As the Photoanode and a Large-Area Titanium Mesh As the Photocathode

Cr(Ⅵ) REDUCTION BY CATALYTIC HYDROGENATION WITH Pd/Al_2O_3 CATALYSTS

Controllable preparation and efficient visible-light-driven photocatalytic removal of Cr(VI) using optimized Cd0.5Zn0.5S nanoparticles decorated H-Titanate nanotubes

Palladium Nanoparticles Uniformly and Firmly Supported on Hierarchical Flower-Like TiO2 Nanospheres As a Highly Active and Reusable Catalyst for Detoxification of Cr(VI)-contaminated Water

Palladium nanoparticles supported on aluminum oxide (Al2O3) for the catalytic hexavalent chromium reduction

Highly improved visible-light-driven photocatalytic removal of Cr(VI) over yttrium doped H-Titanate nanosheets and its synergy with organic pollutant oxidation

Synergy of Photocatalysis and Adsorption for Simultaneous Removal of Cr(VI) and Cr(III) with TiO2 and Titanate Nanotubes

Factors Influencing the Photoelectrocatalytic Reduction of Cr(Vi) over Tio2 Nanotube Arrays

Removal of Hexavalent Chromium from Wastewater by Cu/Fe Bimetallic Nanoparticles

Porous carbon nanofiber/porphyrin-based metal organic frameworks/TiO 2 nanoparticles ternary materials for selective detection and photoreduction of Cr(VI)

Investigations on Photoelectrocatalytic Reduction of Cr(VI) over Titanium Dioxide Anode and Metal Cathode

The removal mechanism of Cr(VI) by calcium titanate: Insight into the role of surface reduced Cr(III) in removal process

Pd sub-nanolayer on Au core for enhanced catalytic hydrogenation reduction of oxyanions pollutants: Synergistic effect of Pd and Au

Optimizing Cr(VI) reduction to Cr(III) using Pd-CNTs nanocatalyst: kinetic Monte Carlo simulation and experimental design insights

Fabrication of Ti-PDA nanoparticles with enhanced absorption and photocatalytic activities for hexavalent chromium Cr(VI) removal

Porous Polyurea Supported Pd Catalyst: Easy Preparation, Full Characterization, and High Activity and Reusability in Reduction of Hexavalent Chromium in Aqueous System