Abstract:Ultrasound is commonly utilized to determine the dynamic Young's moduli for estimating material deterioration or quantifying material parameters. This is either done with a resonance frequency analysis or ultrasound for rock or concrete specimens in geophysics or civil engineering. For ultrasound, these are typically cylindrical specimens measured in a through-transmission arrangement. However, this method presents some challenges, such as the need to accurately determine the onset of each wave mode and to calibrate system latency. To overcome these challenges, this study introduces a novel method that utilizes wavefield simulation and full-waveform inversion to estimate p- and s-wave, also called compression and shear wave, velocities. Where the traditional method requires two measurements, this innovative approach requires only one measurement with a single p-wave transducer. The s-wave velocity is estimated considering mode conversions within the specimen. High-fidelity ultrasound simulations are necessary for this approach. For that reason, the spatially distributed excitation of the ultrasound transducer is characterized by a laser Doppler vibrometer measurement. This led to a good estimate of the directivity pattern of the ultrasound transducer. The inverse problem for determining p- and s-wave velocity was solved successfully using a suitable misfit or cost function, the so-called graph-optimal-transport misfit. The specimens for the proof of concept study include six different metals. The precision of the estimated velocities using full-waveform inversion was compared with manual picking. As the simulated and measured waveforms matched well, this study can be seen as a starting point for material parameter determination for more complex geometries and heterogeneous materials using full-waveform inversion.

All-optical measurement of in-plane and out-of-plane Young's modulus and Poisson's ratio in silicon wafers by means of vibration modes

Simultaneous determination of Young's modulus and Poisson's ratio in metals from a single surface using laser-generated Rayleigh and leaky surface acoustic waves

Measurement Technique for Elastic and Mechanical Properties of Polycrystalline Silicon-Germanium Films Using Surface Acoustic Waves and Projection Masks

Determining Young's modulus via the eigenmode spectrum of a nanomechanical string resonator

Measurement of Young's modulus and residual stress of silicon microstructures

Anelastic Internal Friction and Mechanical Spectroscopy of SiO2/Si Wafers

Microscopic observation of strain induced in heteroepitaxial layers with reflection type of infrared polariscope

Simultaneous measurement of the Young's modulus and the Poisson ratio of thin elastic layers

Laser Self-Mixing Sensor for Simultaneous Measurement of Young’s Modulus and Internal Friction (Invited)

Optical anisotropy and strain-induced birefringence in dislocation-free silicon single crystals

A Method For Quantitative Evaluation Of Electrical Conductivity Of Silicon Wafers By Millimeter-Waves

Polarimetric analysis of stress anisotropy in nanomechanical silicon nitride resonators

Resonance Test for Modulus of Elasticity and the Poisson Ratio of Plate-Shaped Materials

A Method of Measuring Young's Modulus and Residual Stress in Typical MEMS Structures Using a Surface Profilometer

Phase-Shifted Reflective Coherent Gradient Sensor for Measuring Young'S Modulus and Poisson'S Ratio of Polished Alloys

A new method for identifying elastic parameters of isotropic materials based on square specimens

Analysis of photoelastic properties of monocrystalline silicon

Measuring Poisson's ratio during nanoindentation via lateral contact stiffness; issues of slip and plasticity

Complex Young's Modulus Measurement by Incident Wave Extracting in a Thin Resonant Bar

Estimating Young's moduli based on ultrasound and full-waveform inversion

Time-multiplexed laser self-mixing sensor for measurement of multiple material elastic moduli