Friction and wear properties of hydraulic components with ceramic/steel-to-steel pairs

Baofu Kou,Zhenshun Li,Zhang Zhang,Ruiqing Li

DOI: https://doi.org/10.1007/s12206-021-0711-0

IF: 1.81

2021-07-22

Journal of Mechanical Science and Technology

Abstract:The friction coefficient and wear amount of ceramic/steel-to-steel pairs under various concentrations of high water-based emulsion, load size, and load frequency were investigated through friction and wear test, white light interference 3D surface profiling, scanning electron microscopy, and attached energy spectrometry. The friction and wear conditions of hydraulic components made of different materials are discussed. The ceramic-to-steel pair performs better than the steel-to-steel pair in friction reduction and wear resistance. When the load is 100 N, the frequency is 1 Hz and the concentration is 6 %, and the friction coefficient and wear amount of the ceramic-to-steel pair are the lowest. The degree of abrasive and ploughing wear of various friction pairs is directly proportional to the emulsion concentration and inversely proportional to the working load and frequency. The research results can provide guidance for the manufacture and application of ceramic valves.

engineering, mechanical

What problem does this paper attempt to address?

This paper aims to study the friction coefficient and wear amount of ceramic/steel and steel/steel friction pairs under different concentrations of high - water - based emulsions, load magnitudes and load frequencies. Through friction and wear tests, white - light interference 3D surface profile measurement, scanning electron microscopy and energy - dispersive spectroscopy analysis, the friction and wear conditions of hydraulic components made of different materials were explored. The research shows that under a load of 100 N, a frequency of 1 Hz and an emulsion concentration of 6%, the ceramic/steel friction pair has the lowest friction coefficient and wear amount. In addition, the degrees of abrasive wear and ploughing wear are directly proportional to the emulsion concentration and inversely proportional to the working load and frequency. These research results can provide guidance for the manufacturing and application of ceramic valve cores.

Specifically, the paper attempts to solve the following key problems:
1. **Improve mechanical efficiency and service life**: By studying the friction and wear properties of ceramic/steel friction pairs in high - water - based emulsions, it aims to improve the mechanical efficiency and service life of hydraulic components.
2. **Optimize parameter selection**: Determine the optimal parameter combination of ceramic/steel friction pairs under different load, frequency and emulsion concentration conditions to achieve the lowest friction coefficient and wear amount.
3. **Compare material properties**: Compare the friction and wear properties of ceramic/steel and steel/steel friction pairs under different conditions, and evaluate the advantages of ceramic materials in reducing friction and wear.
4. **Provide technical guidance**: Provide technical support and theoretical basis for the design and application of new ceramic - valve - core hydraulic components using high - water - based emulsion media.

Through these studies, the paper hopes to provide a scientific basis for the application of ceramic materials in hydraulic systems, especially in the hydraulic systems of large - scale mining equipment, and to extend the service life and improve the working efficiency of hydraulic components by improving material properties.