Abstract:Polymers find widespread use in applications where they are subjected to impact loading. Therefore, understanding the time dependence of their mechanical response is critical to the design of structures subjected to these high strain rate environments. However, characterising these materials on microsecond time scales has proven challenging. Traditional experimental techniques rely on satisfying a number of limiting assumptions and typically do not provide direct measurements of the material parameters. Here, we propose a novel implementation of the image‐based inertial impact (IBII) test to extract viscoelastic constitutive parameters on these microsecond time scales using the stress gauge implementation of the virtual fields method. We validate the experiment using a digital replica approach in which the constitutive parameters are first extracted on a finite element model of an IBII test on a viscoelastic material. The finite element data are then used to synthetically deform computer‐generated grid images, which are then polluted with grey‐level noise to simulate the images that would be captured in a real‐life experiment. These images are processed identically to a physical experiment, and the identification is repeated using the full‐field displacements extracted from the computer‐generated images to determine the ideal processing parameters. Parameter identification was found to strongly depend on the processing parameters used to extract the kinematic fields from full‐field images, emphasising the need for computational validation before attempting a physical experiment to extract constitutive parameters. The IBII experimental method was found to be capable of simultaneously identifying the bulk modulus and the shear modulus along with their associated time constant.

Instrumented Taylor impact test for measuring stress-strain curve through single trial

Instrumented indentation measurements of residual stresses around a crack tip under single tensile overloads

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

Validation of the material point method and plasticity with Taylor impact tests

A Critical Appraisal of the Instrumented Indentation Technique and Profilometry‐Based Inverse Finite Element Method Indentation Plastometry for Obtaining Stress–Strain Curves

Beyond Hopkinson's bar

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Stress–Strain Curve Estimation from Load–depth Curve of Spherical Indentation Test Based on Finite Element Analysis and Optimization

Dynamic stress-strain curves for various plastics and fibre-reinforced plastics

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Determining plastic properties of a material with residual stress by using conical indentation

Image‐based inertial impact test for viscoelastic constitutive identification: A digital replica for error quantification

Identification of True Stress-Strain Curve of Thermoplastic Polymers under Biaxial Tension

The use of the Hopkinson bar to validate constitutive relations at high rates of strain

Image-Based Inertial Impact Test for Composite Interlaminar Tensile Properties

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Data-driven estimation of plastic properties in work-hardening model combining power-law and linear hardening using instrumented indentation test

Experimental analysis of the multiaxial failure stress locus of commercially pure titanium at low and high rates of strain

High Strain Rate Response of In-Situ TiB2/7055 Composite by Taylor Impact

Evaluation of tensile stress-strain curve of electroplated copper film by characterizing indentation size effect with a single nanoindentation