Abstract:Control of low-concentration pollutants from a semiconductor process vent stream using a wet-scrubbing technique is a challenging task to meet Taiwan environmental emission standards. An efficient wet-scrubber is designed on a pilot scale and tested to control low concentration acid and base waste-gas emission. The scrubber system consisted of two columns, i.e., a fine spray column [cutoff diameter (based on volume), Dv(50) = 15.63 microm; Sauter mean diameter (SMD) = 7.62 microm], which is especially efficient for NH3 removal as the pH of the spraying liquid is approximately 7 followed by a packed column with a scrubbing liquid pH approximately 9.0 mainly for acids removal. It is observed that use of the surfactants in low concentration about 10(-4) M and 10(-7) M in the spray liquid and in the scrubbing liquid, respectively, remarkably enhances the removal efficiency of the system. A traditional packed column (without the spray column and the surfactant) showed that the removal efficiencies of NH3, HF, and HCl for the inlet concentration range 0.2 to 3 ppm were (n = 5) 22.6+/-3.4%, 43.4+/-5.5%, and 40.4+/-7.4%, respectively. The overall efficiencies of the proposed system (the spray column and the packed column) in the presence of the surfactant in the spray liquid and in the scrubbing liquid forthese three species were found to increase significantly (n = 5) from 60.3+/-3.6 to 82.8+/-6.8%, 59.1+/-2.7 to 83.4+/-4.2%, and 56.2+/-7.3 to 81.0+/-6.7%, respectively. In this work, development of charge on the gas-liquid interface due to the surfactants has been measured and discussed. It is concluded that the presence of charge on the gas-liquid interface is the responsible factor for enhancement of the removal efficiency (mass-transfer in liquid phase). The effects of the type of surfactants, their chain length, concentration in liquid, etc. on the removal efficiency are discussed. Since the pilot tests were performed under the operating conditions similar to most of the wet-scrubbers operated in semiconductors manufacturing facilities for inorganic pollutants, this study can be applied to modify the existing wet-scrubbers to enhance the removal efficiencies, especially for low-concentration pollutants.

High-Temperature Scrubbing of Halogenated Compounds

Investigation on Incineration of Salty Organic Wastewater

Experimental Investigation of the Reactivity of Sodium Bicarbonate toward Hydrogen Chloride and Sulfur Dioxide at Low Temperatures

Removal of Carbon Tetrachloride in Waste Water Using Alkali Catalytic Oxidization Method

Experimental Study on Removal of Alkali-Metal and Incineration of High Concentration Organic Liquid Wastes

Experimentation Study on Removal Chlorine from Incineration Fly Ash by Washing Process

Migration and Agglomeration of Chlorine in Dechlorination of Coal-Fired Flue Gas

Wet Oxidation and Absorption Procedure for NOx Removal

Dry scrubbing of municipal solid waste incineration flue gas using porous sodium carbonate produced via vacuum thermal treatment of sodium bicarbonate

Process optimization and mechanism for removal of high-concentration chlorine from municipal solid waste incineration fly ash washing wastewater by Friedel's salt

Chloride Salt Purification by Reaction With Thionyl Chloride Vapors to Remove Oxygen, Oxygenated Compounds, and Hydroxides

B202 In-furnace Reduction of HCI Emission by Alkali-based Sorbents During PVC Combustion in Fixed Bed

Behavior and Control of Chlorine in Dyestuff Residue Incineration

Effects of Halides on Organic Compound Degradation during Plasma Treatment of Brines

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation

Efficient control system for low-concentration inorganic gases from a process vent stream: application of surfactants in spray and packed columns

In-Place Hepa Filter Testing by the Sodium Flame Method

High temperature reduction of divalent mercury to elemental mercury for Hg-CEMS

Experimental Study of HCl Emission and Removal on Incinerating of Typical MSW Components in Fluidized Bed

Development of an Evaporation Crystallizer for Desalination of Alkaline Organic Wastewater Before Incineration

Dichlorination in a Circulating Fluidized-Bed Incinerator for Municipal Solid Waste Incineration System