Abstract:Residual stress constitutes an integral part of the total stress acting on any component in service. It is imperative to determine residual stress to estimate the life of critical engineering components, especially those that are welded. The stresses caused by non-uniform temperature distribution due to welding and the effect of these multiaxial stresses upon service performance are discussed. A controlled thermal severity test (CTS) was performed on mild steel plates bolted together, with anchor welds deposited on opposite sides. After cooling, bithermal and trithermal test welds were deposited one after the other. Varying welding stresses were deliberately introduced by using different thicknesses of both plates to change the thermal severity numbers (TSN). The main experimental technique used here to determine the magnitude and nature of residual stress is based on X-ray diffraction (XRD). It was utilised to develop and standardise other techniques. The XRD method is based on the peak shiftin the diffraction profile due to the presence of stress using a sin2 ψ method. The peak shift is determined by orienting the sample at different angles ± ψ to the incident X-ray beam. The semidestructive technique of hole drilling and use of a strain gauge was also employed to determine residual stress in CTS specimens. The magnitude, nature, and direction of principal stresses were determined by relieving stresses through incremental blind hole drilling and measuring strain values at each step. The surface displacements arising due to hole drilling can also be determined by laser holography. A sandwich holography technique was developed to avoid unwanted rigid body motions of samples due to hole drilling when relieving stresses. Stress values were obtained by measuring fringe displacement between two exposures of a sandwich hologram, due to hole drilling. Results on the change in residual stress values with TSN are discussed. The residual stress values determined by XRD and sandwich holography were found to be comparable, and stress values obtained by hole drilling/strain gauge measurement were higher than these values. The reasons are discussed.

Comparison of methods of residual-stress measurement

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

COMPUTATIONAL AND EXPERIMENTAL STUDY OF THE STRESS-STRAIN STATE OF A PIPE UNDER EXTERNAL RADIAL LOAD, INTERNAL PRESSURE AND TEMPERATURE DIFFERENCE

The impact of residual technological stresses on the opening and stability of through cracks in pipeline elements

Development and comparison of residual stress measurement on welds by various methods

Surface Stress Analysis of Internally Corroded Pipes under External Pressure

Estimation of stress-strain state of a gas pipeline section with different types of defects

Pressure test method of safety assessment on existed submarine pipeline

The Research on the Stress Analysis of Overhead Steam Pipeline

Comparison of Residual Stress Measurements Conducted by X-ray Stress Analysis and Incremental Hole Drilling Method

The Analysis of the Influence of Various Factors on the Development of Stress Corrosion Defects in the Main Gas Pipeline Walls in the Conditions of the European Part of the Russian Federation

THE INFLUENCE OF PIPE STRESS STATE ON THE PITTING CORROSION RATE OF OILFIELD PIPELINES

Effect of residual tensile stress on stress corrosion behavior of the base metal of x80 uoe pipe

Experimental Evalua tion of the Mechanical Properties of the Metal of the Characteristic Zones of Typical Pipeline Elements

Methods for the residual life assessment of corroded gas pipelines

Residual Stress Measurement Using EMAT for X80 Pipeline Steel: Effects of Coating Thickness and Surface Roughness Under Low Surface Preparation Requirements

Welding residual stress analysis of the X80 pipeline: simulation and validation

Effect of Cyclic Loading on the Relaxation of Residual Stress in the Butt-Weld Joints of Nuclear Reactor Piping

Residual Stress Measurement Techniques for Metal Joints, Metallic Coatings and Components in the Railway Industry: A Review

Residual-Stress, Material Characterization in P22 HRSG-Pipeline Butt Joint