Abstract:The issue of wear failure in High-Pressure Abrasive Water Jet (HP-AWJ) nozzles is an unavoidable challenge, and studying methods to enhance and predict the effective lifetime of nozzles is worth deep exploration. This paper employs a CFD-DEM coupling numerical approach to investigate wear phenomena inside the HP-AWJ nozzle, aiming to capture the realistic particle wear and erosion failure issues at the focusing tube region, which is a high-wear area of the HP-AWJ nozzle. Furthermore, the study considers realistic particles and nozzle wall constitutive models, incorporating material properties into the physical model, and employs computer-aided design methods to reflect wear failure conditions at different time intervals in the inner wall of the focusing tube at the nozzle. The results demonstrate that the number of realistic particles and initial inlet velocity has no impact on the particle exit kinetic energy. However, the particle-wall restitution coefficient affects the average particle kinetic energy at the outlet in the AWJ nozzle. The equivalent model of the realistic particles reflects the influence of the particle roundness on particle kinetic energy, acceleration, and stress concentration variations in the nozzle. These variations further affect the particle erosion rate on the nozzle wall and the actual wear failure problems on the wall surface. Finally, by combining the proposed erosion and wear model, a representative erosion profile at the AWJ focusing tube location comparable to experimental results is obtained, and the wear depth of the focusing tube changing with time is also studied. The results and methodologies presented in this paper provide valuable guidance for controlling the effective service lifetime of the AWJ nozzle, improving machining efficiency, and extending the lifespan of the AWJ nozzle.

Optimization of Abrasive Water Jet Nozzle Based on Numerical Simulation

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Simulation and Optimization of the Nozzle Section Geometry for a Suspension Abrasive Water Jet

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Numerical research on multi-particle movements and nozzle wear involved in abrasive waterjet machining

Numerical Analysis of Swirling-Abrasive Water Jet Flow in the Nozzle

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation

Waterjet Penetration Simulation by Hybrid Code of SPH and FEA

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

Multiphase flow and nozzle wear with CFD-DEM in high-pressure abrasive water jet

A study of abrasive waterjet characteristics by CFD simulation

Research on the structures and hydraulic performances of the typical direct jet nozzles for water jet technology

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Structure optimization of submerged water jet cavitating nozzle with a hybrid algorithm

Numerical Prediction of Solid Particle Erosion in Jet Pumps Based on a Calibrated Model

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Internal mixing chamber flow field of a premixed abrasive water jet descaling nozzle

Numerical investigation into the abrasive particle movement characteristics inside the swirling impeller nozzle based on the coupled SPH-FEM method

Numerical Study and Structural Optimization of Impinging Jet Heat Transfer Performance of Floatation Nozzle

Modeling method and experimental study on the random distribution of abrasive particles in the jet cutting process

Numerical Simulation of Cavitation of Water Jet Nozzle Based on Realizable k-ε Model