Abstract:Abrasive water jet (AWJ) is one of the most modern rock drilling methods. Many numerical investigations have been conducted to study the changes occurring the rock microstructure (i.e., near wall rock damage) during the AWJ rock cutting process. Most of the existing models, however, did not consider the breakage of abrasive particles used for AWJ drilling and therefore, could not simulate the actual rock cutting conditions. In this study, we propose an improved AWJ rock cutting model that considers the effects of the shape, the interaction and the fragmentation of abrasive particles. A coupled smoothed particle hydrodynamics (SPH) and finite element method (FEM) method was used for numerical modeling of AWJ rock cutting process. Model predictions were validated by using the experimental results. Differences between the rock cutting characteristic predicted by the existing model and the newly proposed model were compared. The new model was also used to determine the effects of the operational parameters on the AWJ rock cutting performance. Moreover, the influence of the abrasive particles' breakage on the rock damage characteristics is discussed. The results show that the error between the experimental and the numerical model prediction of the dimensionless AWJ impact diameter is 15.77%. The existing model overestimates the rock damage degree. The rock damage degree tends to increase with an increase in the abrasive particle size (diameter), abrasive jet impact velocity, the impact angle and with a decrease in the abrasive particle mass concentration and rock confining pressure. Compared with the flat surface rock, the damage degree of convex surface rock decreases, while that of concave surface rock increases. The rock damage degree under the condition of no abrasive particle breakage is higher than that of the abrasive particle breakage.

Numerical investigation into the abrasive particle movement characteristics inside the swirling impeller nozzle based on the coupled SPH-FEM method

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Numerical Analysis of Swirling-Abrasive Water Jet Flow in the Nozzle

Numerical Simulation of Sloshing in the Propellant Tank of Reusable Rocket Vehicle Using Meshfree Method

Numerical research on multi-particle movements and nozzle wear involved in abrasive waterjet machining

Flow Field Simulation of Swirling Abrasive Jet Nozzle for Hard Rock Breaking

Numerical study of swirl nozzle internal flow field : Launcher Technology

Numerical Investigation of Abrasive Water Jet Rock Damage Characteristics That Considers the Shape, the Interaction and the Fragmentation of Abrasive Particles

Waterjet Penetration Simulation by Hybrid Code of SPH and FEA

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Numerical simulation of wedges slamming non-Newtonian fluids based on SPH method

Numerical and experimental investigation of flow in swirling nozzle

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation

Multiphase flow and nozzle wear with CFD-DEM in high-pressure abrasive water jet

Numerical Simulation of Violent Impinging Jet Flows with Improved SPH Method

Optimization of Abrasive Water Jet Nozzle Based on Numerical Simulation

A numerical study on the in-nozzle cavitating flow and near-field jet breakup of a spirally grooved hole nozzle using a LES-VOF method

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

Numerical Simulation of the Micro-Jet Velocity and Cavitation-Erosion on an Axisymmetric Nozzle

An unresolved SPH-DEM model for simulation of ductile and brittle surface erosion by abrasive water-jet (AWJ) impact

A study on the performance of a swirling–straight composite nozzle