Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

A study of abrasive waterjet characteristics by CFD simulation

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Modeling of the Cutting Front Profile in Abrasive Water Jet Machining Based on the Energy Balance Approach

Analysis of Water Flow through the Active Parts of an Abrasive Water Jet Machine: A Combined Analytical and CFD Approach

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

CFD-Based Study on the Flow and Kinetic Energy Characteristics of a Supercritical Suspended Abrasive Water Jet in the Deep-Sea Environment

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Waterjet Penetration Simulation by Hybrid Code of SPH and FEA

A Model for Abrasive-Waterjet (AWJ) Machining

Numerical Analysis of Swirling-Abrasive Water Jet Flow in the Nozzle

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Optimization of Abrasive Water Jet Nozzle Based on Numerical Simulation

The effect of cutting jet variation on striation formation in abrasive water jet cutting

Design Method of Water Jet Pump Towards High Cavitation Performances

Multiphase flow and nozzle wear with CFD-DEM in high-pressure abrasive water jet

An unresolved SPH-DEM model for simulation of ductile and brittle surface erosion by abrasive water-jet (AWJ) impact

Analytical and experimental modelling of the abrasive water jet cutting of ductile materials

Numerical Modeling and Experimental Study on the Material Removal Process Using Ultrasonic Vibration-Assisted Abrasive Water Jet

Surface removal of ductile metal using cyclic low-frequency impact of a discrete particle-less waterjet

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation