Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

Analysis of Water Flow through the Active Parts of an Abrasive Water Jet Machine: A Combined Analytical and CFD Approach

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

A study of abrasive waterjet characteristics by CFD simulation

Modeling of the Cutting Front Profile in Abrasive Water Jet Machining Based on the Energy Balance Approach

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Numerical Analysis of Swirling-Abrasive Water Jet Flow in the Nozzle

Investigation of the flow phenomena in high-pressure water jet nozzles

Waterjet Penetration Simulation by Hybrid Code of SPH and FEA

Evaluation of the Depth and Width of Cuts after Controlled-Depth Abrasive Water Jet Machining Using Low Pressure

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Analytical and experimental modelling of the abrasive water jet cutting of ductile materials

Track Calculation and Numerical Simulation on Particles in High Pressure Abrasive Water Jet Nozzle

Multiphase flow and nozzle wear with CFD-DEM in high-pressure abrasive water jet

Two-way coupled CFD-DEM model of a pre-mixed abrasive water jet and its application to the investigation of abrasive motion characteristics

A Model for Abrasive-Waterjet (AWJ) Machining

Internal mixing chamber flow field of a premixed abrasive water jet descaling nozzle

Modelling and analysis of abrasive water jet cut surface topography

CFD analysis of thermal fields for ice abrasive water jet

Numerical research on multi-particle movements and nozzle wear involved in abrasive waterjet machining

Revised Model of Abrasive Water Jet Cutting for Industrial Use