Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

Modeling of the Cutting Front Profile in Abrasive Water Jet Machining Based on the Energy Balance Approach

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Analytical Modeling of Effective Depth of Cut for Ductile Materials Via Abrasive Waterjet Machining

Predicting the geometric morphology of water jet machining in ultra-thick CFRP laminates based on analytical modeling

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Energy Modeling for Variable Material Removal Rate Machining Process: an End Face Turning Case

A Model for Abrasive-Waterjet (AWJ) Machining

Integrated error modeling for abrasive waterjet cutting at various nozzle tilt angle

Modeling the shape profile of the machining side trimmed by abrasive water jet

Study on Cutting Speed and Energy Utilization Rate in Processing Stainless Steel with Abrasive Water Jet

A Fuzzy Control Model Of Metal Cutting With Abrasive Waterjet

Experimental Research of Processing Parameters in Abrasive Water Jet Cutting

Modeling of cutting of stainless steel AISI 304 by abrasive water jet

Numerical Modeling and Experimental Study on the Material Removal Process Using Ultrasonic Vibration-Assisted Abrasive Water Jet

Determination of Rotary Cutting Depth on Steel Pipes with the Abrasive Water Jet Technique

Theoretical Modeling Method for Material Removal Characteristics of Abrasive Water Jet Polishing under Rotating Oblique Incidence

A surface roughness model in radial-mode abrasive waterjet turning for high-tensile steels

A Predictive Depth of Penetration Model for Abrasive Waterjet Cutting of Polymer Matrix Composites

Modelling of the abrasive water jet cutting process

An Investigation into the Radial-Mode Abrasive Waterjet Turning Process on High Tensile Steels

Theoretical Analysis on the Machining Mechanism in Ultrasonic Vibration Abrasive Waterjet