Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Research on Reinforced Concrete Beam-Steel Tube Concrete Column Node

Experimental Research on Seismic Behavior of Reinforced Concrete Column-to-Steel Beam Joints with Bolted End-plate

Analysis of a New H-section Beam to Rectangular Tube Column Connection

Overview of the Current Research Status of Concrete-Filled Steel Tube

Theory Of Concrete-Filled Steel Tubular Structures In China

Recent Developments in Concrete-Filled Steel Tubular Structures in China

Experimental investigation of thin-walled concrete-filled steel tube columns with reinforced lattice angle

Research on Behavior of the Joint with Concrete-filled Steel Tubular Column Under Pre-load in Steel Tube

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Concrete Filled Steel Tubular Structures from Theory to Practice

Research on seismic performance of prefabricated concrete-filled steel tubular frame joints

Analysis on Composite Action of Concrete-Filled Steel Tube Columns Reinforced by Different Confining Materials

Design and seismic performance analysis of a novel special-shaped steel tube concrete column steel beam joint

Experimental investigation on joints between steel-reinforced concrete T-shaped column and reinforced concrete beam under bidirectional low-cyclic reversed loading

A series research of theory and key problems for concrete-filled steel tube

New Connection System for Confined Concrete Columns and Beams. I: Experimental Study

Investigation on Shear Capacity of Joints between Steel Reinforced Concrete Special-Shaped Column and Reinforced Concrete Beam

Priliminary Research On Behavior Of Composite Joints With Cfst Column To Steel Beam Under Long-Term Loading

Research on seismic behavior of prefabricated concrete beam-column joints

Research and optimization on laminated steel tube column-concrete beam joints with outer stiffening ring

Experimental Study and Theoretical Analyses on Compressive Bearing Capacity of High Strength Concrete-Filled Steel Tube Composite Columns