Abstract:ABSTRACTDeveloped more than 80 years ago, the design procedure of concrete filled steel tubes (CFST) has several limitations that can still be found in most current international design standards. The two main limitations that present themselves are the lack of ability to achieve material enhancement when using high strength materials and restrictions on the geometry of the steel tube thickness to the overall column diameter. This geometric limitation is placed on the design to ensure that the steel tube remains ‘compact’. In complying with these constraints it is assumed in the design equations that local buckling of the steel tube will not take place before the ultimate global buckling load is achieved.With the introduction of higher strength materials, specifically when dealing with steel, the strength increase leads to the design of sections with increased slenderness. As the section becomes more slender, the ability to maintain the compact section limitations in the design codes becomes increasingly difficult. This paper looks at an experimental study on very thin‐walled steel tubes filled with high‐strength concrete and how localised buckling affects their compressive capacity.Adopting a diameter to thickness ratio of 200, 24 circular tubes were constructed using a high‐strength cold‐formed steel sheet, with yield stresses above 500MPa and filled with 100MPa concrete. Employing both thin‐walled sections and high strength materials, the effects of localised buckling in these composite members when subjected to compression has been studied. The experimental programme explored four main conditions; when both the steel and concrete were loaded and bonded together, when the concrete core inside the CFST was loaded, when the steel tube in the CFST was loaded and when the concrete core without the steel tube was tested.By studying the failure modes of both the concrete and the steel tube when acting compositely and individually, the experimental work shows that there is valid evidence to support the theory that even when using high strength materials in slender sections, confinement to the concrete core is provided. Finally, the results of the experimental work have been compared to the compressive design capacities predicted by current international design codes, showing that these provisions are conservative.

Experimental investigation of thin-walled concrete-filled steel tube columns with reinforced lattice angle

Experimental investigation of concrete-filled steel tubular columns with reinforcing lattice angle

Numerical Investigation on Compressive Performance of CFST Columns with Encased Built-Up Lattice-Angles

EXPERIMENTAL INVESTIGATION AND NONLINEAR FINITE ELEMENT ANALYSIS ON THE BEHAVIOR OF CONCRETE-FILLED SQUARE STEEL TUBULAR COLUMN CONNECTIONS

Experimental Investigation of Thin-Walled Complex Section Concrete-Filled Steel Stub Columns

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections

Experimental investigation of self-compacting concrete-filled weather steel tube stub columns

Experiment study of reinforced concrete filled steel tubular columns subjected to axial compression

Experimental Studies On The Strength With High Slenderness Ratio Concrete Filled Steel Tubular Columns

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Axial Compressive Behavior of FRP-confined Square CFST Columns Reinforced with Internal Latticed Steel Angles for Marine Structures

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

Experimental Behaviour of Concrete-Filled Stiffened Thin-Walled Steel Tubular Columns

Axial compression behavior of square section concrete-filled steel tubes reinforced with internal latticed steel angles

Experimental Investigation of Special-Shaped Concrete-Filled Square Steel Tube Composite Columns with Steel Hoops under Axial Loads

08.17: Experimental Behaviour of High‐strength Thin‐walled Concrete Filled Steel Tubular Stub Columns