Evaluating scanning electron microscopy for the measurement of small-scale topography
Vimanyu Chadha,Nathaniel Miller,Ruikang Ding,Kurt E. Beschorner,Tevis David Jacobs
DOI: https://doi.org/10.1088/2051-672x/ad49b9
2024-05-12
Surface Topography Metrology and Properties
Abstract:For predicting surface performance, multiscale topography analysis consistently outperforms standard roughness metrics; however, surface-characterization tools limit the range of sizes that can be measured. Therefore, we evaluate the use of scanning electron microscopy (SEM) to systematically measure small-scale topography. While others have employed SEM for similar purposes, the novelty of this investigation lies in the development and validation of a simple, flexible procedure that can be applied to a wide range of materials and geometries. First, we established four different options that can be used for sample preparation, and we measured quantitative topography of each using the SEM. Then the power spectral density (PSD) was used to compare topography among the four preparations, and against other techniques. A statistical comparison of PSDs demonstrated that SEM topography measurements outperformed AFM measurements at scales below 100 nm and were statistically indistinguishable from (highly labor-intensive) TEM measurements down to 16 nm. The limitations of SEM-based topography are quantified and discussed. Overall, the results show a simple generalizable method for revealing small-scale topography. When combined with traditional stylus profilometry, this technique characterizes surface topography across almost seven orders of magnitude, from 1 cm down to 16 nm, facilitating the use of physical models to predict performance.
materials science, multidisciplinary,engineering, mechanical,instruments & instrumentation