Abstract:The operation of vertical axis wind turbines (VAWTs) to generate low-carbon electricity is growing in popularity. Their advantages over the widely used horizontal axis wind turbine (HAWT) include their low tip speed, which reduces noise, and their cost-effective installation and maintenance. A Farrah turbine equipped with 12 blades was designed to enhance performance and was recently the subject of experimental investigation. However, little research has been focused on turbine configurations with more than three blades. The objective of this study is to employ numerical methods to analyse the performance of the Farrah wind turbine and to validate the findings in comparison with experimental results. The investigated blade pitch angles included both positive and negative angles of 7, 15, 20 and 40 degrees. The k-ω SST model with the sliding mesh technique was used to perform simulations of a 14.4 million element unstructured mesh. Comparable trends of power output results in the experimental investigation were obtained and the assumptions of mechanical losses discussed. Wake recovery was determined at an approximate distance of nine times the turbine diameter. Two large complex quasi-symmetric vortical structures were observed between positive and negative blade pitch angles, located in the near wake region of the turbine and remaining present throughout its rotation. It is demonstrated that a number of recognised vortical structures are transferred towards the wake region, further contributing to its formation. Additional notable vortical formations are examined, along with a recirculation zone located in the turbine's core, which is described to exhibit quasi-symmetric behaviour between positive and negative rotations.

Nonlinear vibration analysis of horizontal axis wind turbine blades using a modified pseudo arc-length continuation method

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

Non-linear dynamic analysis of a wind turbine blade

Nonlinear vibration analysis of wind turbine blades

Multiple scales analysis of out-of-plane and in-plane vibrations of a wind turbine blade

Aeromechanical Analysis of a Complete Wind Turbine Using Nonlinear Frequency Domain Solution Method

Nonlinear Flap-Wise Vibration Characteristics of Wind Turbine Blades Based on Multi-Scale Analysis Method

3D Multiscale Dynamic Analysis of Offshore Wind Turbine Blade under Fully Coupled Loads

Numerical Modeling and Analysis of a Horizontal Axis RM1 NACA-4415 Wind Turbine

MODEL ANALYSIS AND TEST RESEARCH OF HORIZONTAL-AXIAL MARINE CURRENT TURBINE

Out-of-plane vibration mitigation of wind turbine rotor blades using nonlinear energy sink

Fully coupled forced response analysis of nonlinear turbine blade vibrations in the frequency domain

Modal analysis for optimal design of offshore wind turbine blades

Vibration characteristics on a wind turbine rotor using modal and harmonic analysis of FEM

The influence of wind characteristic on aeroelastic stability for wind turbine blades

Nonlinear pitch angle control of an onshore wind turbine by considering the aerodynamic nonlinearities and deriving an aeroelastic model

Nonlinear vibrations of a rotating pretwisted blade

Performance Enhancement of Horizontal Axis Wind Turbine Using Numerical Techniques

CFD Analysis on Novel Vertical Axis Wind Turbine (VAWT)

Structural Design and Stress Analysis of A Helical Vertical Axis Wind Turbine Blade

Inverse Design of Single- and Multi-Rotor Horizontal Axis Wind Turbine Blades using Computational Fluid Dynamics