Abstract:As a single-phase alloy, CrFeCoNi is a face centered cubic (fcc) material related to the archetypical high-entropy Cantor alloy CrFeCoNiMn. For thin films, CrFeCoNi of approximately equimolar composition tends to assume an fcc structure when grown at room temperature by magnetron sputtering. However, the single-phase solid solution state is typically not achieved for thin films grown at higher temperatures. The same holds true for Cantor alloy-based ceramics (nitrides and oxides), where phase formation is extremely sensitive to process parameters such as the amount of reactive gas. This study combines theoretical and experimental methods to understand the phase formation in nitrogen-containing CrFeCoNi thin films. Density functional theory calculations considering three competing phases (CrN, Fe-Ni and Co) show that the free energy of mixing, Δ G of (CrFeCoNi)1−xNx solid solutions has a maximum at x=0.20−0.25 , and Δ G becomes lower when x<0.20 and x>0.25 . Thin films of (CrFeCoNi)1−xNx ( 0.14≥x≤0.41 ) grown by magnetron sputtering show stabilization of the metallic fcc when x≤0.22 and the stabilization of the NaCl B1 structure when x>0.33 , consistent with the theoretical prediction. In contrast, films with intermediate amounts of nitrogen (x=0.22) grown at higher temperatures show segregation into multiple phases of CrN, Fe-Ni-rich and Co. These results offer an explanation for the requirement of kinetically limited growth conditions at low temperature for obtaining single-phase CrFeCoNi Cantor-like nitrogen-containing thin films and are of importance for understanding the phase-formation mechanisms in multicomponent ceramics. The results from the study further aid in making correlations between the observed mechanical properties and the crystal structure of the films. https://doi.org/10.1103/PhysRevMaterials.7.055002 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Funded by Bibsam. Published by the American Physical Society

Formation of a non-magnetic metallic iron nitride layer on bcc Fe(100)

Formation of iron nitride thin films with Al and Ti additives

Formation of Non Equilibrium Solid Phases in Fe-Nb Multilayered Films by Ion Irradiation

Iron nitride thin films deposited by chloride assisted plasma enhanced chemical vapour deposition: facile stoichiometry control and mechanism study

Critical Thickness of Α″-Fe16n2 Layer Prepared in Low-Temperature Nitriding

Vacancy-mediated fcc/bcc phase separation in Fe1-xNix ultrathin films

Phase formation in CrFeCoNi nitride thin films

Preparation of a FeNiN film, its microstructure and its magnetic property analysis

Magnetism and structure of in-situ grown FeN films studied using N K-edge XAS and nuclear resonance scattering

Competing Ferromagnetic and Anti-Ferromagnetic interactions in Iron Nitride $ζ$-Fe$_2$N

Analysis of active screen low temperature plasma-assisted deposition of iron nitride thin films on silicon (100) substrate

Ferromagnetic Fe3N Films Grown on GaN(0002) Substrates by MOCVD

Unusual Iron Nitride Formation Upon Nitriding Fe-Si Alloy

An investigation on nitrogen uptake and microstructure of equimolar quaternary FeCoNiCr high entropy alloy after active-screen plasma nitriding

Growth, magnetic, and electronic properties of Ni-Zn ferrites thin films

Formation of Nanocrystalline Fe–N–B–Cu Soft Magnetic Ribbons

Formation of Ferromagnetic Single-Phase Epsilon-Fe2 Similar to 3N on GaN by Nitridation of Fe Films

Effect of dopants on thermal stability and self-diffusion in iron nitride thin films

Metastable Phase Formation and Magnetic Properties of the Fe–Nb System Studied by Atomistic Modeling and Ion Beam Mixing

Growth of boron nitride nanotubes and iron nanowires from the liquid flow of FeB nanoparticles

Ferromagnetic Fe3N films grown on GaN(0 0 0 2) substrates by MOCVD