Abstract:<h3 class="a-plus-plus">Abstract</h3> <span class="a-plus-plus abstract-section id-a-sec1"> <h3 class="a-plus-plus">Objectives</h3> <p class="a-plus-plus">To investigate the accuracy of bone mineral density (BMD) quantification using dual-layer spectral detector CT (SDCT) at various scan protocols.</p> </span> <span class="a-plus-plus abstract-section id-a-sec2"> <h3 class="a-plus-plus">Methods</h3> <p class="a-plus-plus">Two validated anthropomorphic phantoms containing inserts of 50–200 mg/cm<sup class="a-plus-plus">3</sup> calcium hydroxyapatite (HA) were scanned using a 64-slice SDCT scanner at various acquisition protocols (120 and 140 kVp, and 50, 100 and 200 mAs). Regions of interest (ROIs) were placed in each insert and mean attenuation profiles at monochromatic energy levels (90–200 keV) were constructed. These profiles were fitted to attenuation profiles of pure HA and water to calculate HA concentrations. For comparison, one phantom was scanned using dual energy X-ray absorptiometry (DXA).</p> </span> <span class="a-plus-plus abstract-section id-a-sec3"> <h3 class="a-plus-plus">Results</h3> <p class="a-plus-plus">At both 120 and 140 kVp, excellent correlations (R = 0.97, P < 0.001) were found between true and measured HA concentrations. Mean error for all measurements at 120 kVp was -5.6 ± 5.7 mg/cm<sup class="a-plus-plus">3</sup> (-3.6 ± 3.2%) and at 140 kVp -2.4 ± 3.7 mg/cm<sup class="a-plus-plus">3</sup> (-0.8 ± 2.8%). Mean measurement errors were smaller than 6% for all acquisition protocols. Strong linear correlations (R<sup class="a-plus-plus">2</sup> ≥ 0.970, P < 0.001) with DXA were found.</p> </span> <span class="a-plus-plus abstract-section id-a-sec4"> <h3 class="a-plus-plus">Conclusions</h3> <p class="a-plus-plus">SDCT allows for accurate BMD quantification and potentially opens up the possibility for osteoporosis evaluation and opportunistic screening in patients undergoing SDCT for other clinical indications. However, patient studies are needed to extend and translate our findings.</p> </span> <span class="a-plus-plus abstract-section id-a-sec5"> <h3 class="a-plus-plus"> <em class="a-plus-plus">Key points</em> </h3> <p class="a-plus-plus">• <em class="a-plus-plus">Dual</em>-<em class="a-plus-plus">layer spectral detector CT allows for accurate bone mineral density quantification</em>.</p> <p class="a-plus-plus">• <em class="a-plus-plus">BMD measurements on SDCT are strongly linearly correlated to DXA</em>.</p> <p class="a-plus-plus">• <em class="a-plus-plus">SDCT</em>, <em class="a-plus-plus">acquired for several indications</em>, <em class="a-plus-plus">may allow for evaluation of osteoporosis</em>.</p> <p class="a-plus-plus">• <em class="a-plus-plus">This potentially opens up the possibility for opportunistic osteoporosis screening</em>.</p> </span>

Accuracy and precision of volumetric bone mineral density assessment using dual-source dual-energy versus quantitative CT: a phantom study

The Accuracy of Bone Mineral Density Measurement Using Dual-Energy Spectral CT and Quantitative CT: a Comparative Phantom Study

The new fast kilovoltage-switching dual-energy computed tomography for measuring bone mineral density

Accuracy of bone mineral density quantification using dual-layer spectral detector CT: a phantom study

Diagnostic Accuracy of Dual-Energy CT Material Decomposition Technique for Assessing Bone Status Compared with Quantitative Computed Tomography

Bone mineral density measurements derived from dual-layer spectral CT enable opportunistic screening for osteoporosis

Accuracy of Phantomless Calibration of Routine Computed Tomography Scans for Opportunistic Osteoporosis Screening in the Spine Clinic

A preliminary study of the correlation and agreement of bone mineral density measurements between rapid-kilovoltage-switching dual-energy CT and QCT

Quantitative assessment of areal bone mineral density using multi-energy localizer radiographs from photon-counting detector CT

Evaluation of precision and accuracy of bone mineral densitometry

Validation of Asynchronous Quantitative Bone Densitometry of the Spine: Accuracy, Short-Term Reproducibility, and a Comparison with Conventional Quantitative Computed Tomography

Quantitative computed tomography has higher sensitivity detecting critical bone mineral density compared to dual-energy X-ray absorptiometry in postmenopausal women and elderly men with osteoporotic fractures: a real-life study

Quantitative calcium-based assessment of osteoporosis in dual-layer spectral CT

Accuracy, Agreement, and Reliability of DECT-derived Vbmd Measurements: an Initial Ex Vivo Study.

Asynchronous calibration of quantitative computed tomography bone mineral density assessment for opportunistic osteoporosis screening: phantom-based validation and parameter influence evaluation

The Quantification of Bone Mineral Density Using Photon Counting Computed Tomography and its Implications for Detecting Bone Remodelling

Multi-site phantomless bone mineral density from clinical quantitative computed tomography in males

Comparison of bone mineral density measured by quantitative computed tomography and dual energy CT at the lumbar spine

Long-Term Reproducibility of BMD-Measurements with Clinical QCT Using Simultaneous and Asynchronous Calibration Methods and Different Measurement and Reconstruction Protocols

Bone Mineral Density at the Ankle Measured with Quantitative CT (QCT)

Interobserver variability in the determination of bone mineral density in Hounsfield units from differently configured fields of measurement in the cancellous bone of vertebral bodies from elderly body donors