Abstract:Recently tetrapod piled jacket (TPJ) foundations are considered as a promising solution for offshore wind turbines in waters with depths ranging from 20 m to 50 m. This paper presents a numerical study into the monotonic lateral loading behaviour of TPJ foundations in medium sand, in terms of overall load-displacement responses of TPJ foundations and internal force within individual corner piles as well as pile-soil interaction. The results of previous centrifuge model tests are used to provide high-quality verification for the development of a 3D finite element model established by ABAQUS. A series of parametric studies is then carried out to look into more detailed response of TPJ foundations subjected to lateral loads, including the influence of spacing and slenderness ratio of piles, loading height as well as soil friction angle. The numerical results show that there are two various deformation models of TPJ foundations during lateral loading. One is shearing dominated deformation model under smaller loads, while another one is overturning dominated model under larger loads. Moreover, the lateral soil-pile interaction is found to be greatly influenced by enhancing/weakening effects of the axial forces of individual piles. The cause of this phenomenon is primarily due to the change in soil stress induced by pile vertical movement and radial deformation. To quantify this effect on pile-soil interaction of TPJ foundation, an enhancement factor Gamma(s), defined as the ratio of the soil resistance on downwind piles to that on upwind piles, is proposed. Consequently, the relationship between Gamma(s), depth of influence zone z(c )and four parameters are carefully investigated. For simplicity, the Gamma(s) is assumed constant and independent with pile lateral deflection as well as soil depths, based on which the values for Gamma(s) and z(c) are recommended for practical design uses. It is highlighted in the present study that these values should be chosen based on the specific loading conditions to provide much safer and more robust design for TPJ foundations.

MPM simulation of uplift resistance of enlarged base piles in sand

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Three-Dimensional DEM Simulation of Plugging Behaviour of Small-Diameter Open-Ended Model Piles Penetrating Into Sand

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Performance of laterally loaded H-piles in sand

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Centrifuge Modelling for Seismic Response of Single Pile for Wind Turbine Subjected to Lateral Load

MPM Simulation of the Installation of an Impact-Driven Pile in Dry Sand and Subsequent Axial Bearing Capacity

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Material point method simulations of displacement pile and CPT penetration in sand considering the effects of grain breakage

Numerical Investigation on the Lateral Loading Behaviour of Tetrapod Piled Jacket Foundations in Medium Dense Sand

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

A P-Y Curve Method for Horizontal Bearing Characteristics of Single Batter Pile in Sands