Oxidative dehydrogenation of n-butane on MgO-supported vanadium oxide catalysts

J.M López Nieto,A Dejoz,M.I Vazquez,W O'Leary,J Cunningham
DOI: https://doi.org/10.1016/s0920-5861(98)00010-8
IF: 5.3
1998-04-01
Catalysis Today
Abstract:Vanadium–magnesium oxide (VMgO) catalysts have been prepared, characterized and tested in the ODH of n-butane. The catalysts were prepared by two variations of the wet-impregnation method using aqueous ammonium metavanadate or organically-based methanolic vanadyl acetylacetonate solutions. The catalyst surface area depends on the vanadium content and the preparation method. Catalyst characterization (i.e. XRD, 51V NMR, FTIR, LRS) results indicate the presence of poor crystalline Mg-orthovanadate (Mg3V2O8), while the presence of other Mg-vanadates is not clear. Oxygen isotopic-exchange experiments on VMgO catalysts indicate an R2 process: [18O2+216O2−(s)→(18O18O16O16O)4−(s)→218O2−(s)+16O2(g)] at temperatures higher than 1023K, while an R0-type [18O2(g)+16O2(g)→216O18O(g)] is observed at 823K, as a consequence of a small activity for homophase isotopic. Both the catalytic activity and the selectivity to oxydehydrogenation products depend on the vanadium content but is independent on the catalyst preparation method. This behavior is observed in the ODH of n-butane with both O2 and N2O. However, while conversion of n-butane was higher when using O2 as oxidant, the selectivity to C4-olefins was higher with N2O as oxidant. Pulse experiments show that prereduced surfaces are not effective in producing olefins while selective catalysts are achieved with preoxidized surface. A mechanism for the oxidative dehydrogenation of n-butane is proposed.
chemistry, physical,engineering, chemical, applied
What problem does this paper attempt to address?