Abstract:This paper analyzes the current characteristics of short circuit and open circuit of single thyristor as well as the current characteristics of open circuit of AC line, and comes up with a new on-line fault diagnosis method for the rectifier device. For the single thyristor short circuit, the theoretical DC value calculated using the measured AC current will be greater than the real-time DC value measured, and the DC components of the fault phase and non-fault phase are opposite in sign, which can be used to locate the fault thyristor. In the open circuit situation, if the DC component value of current calculated by slide window is continually larger than the threshold value, it is single thyristor open circuit, and the fault thyristor can be identified by the sign of fault phase DC component; if the DC component value of current firstly increases above a certain value and then reduces to 0, the fault can be identified as AC line open circuit, and the fault phase can be located with the help of minimum amplitude of the fundamental wave. This method takes both open circuit and short circuit faults into consideration, and it can also be applied to the fault diagnosis of multiple parallel rectifiers. Simulation results show that the fault identification speeds are 1ms, 10ms, and 2ms in thyristor short circuit, thyristor open circuit, and AC line open circuit cases respectively, and that the fault location speeds are 20ms, 30ms, and 22ms correspondingly. The method can diagnose the faults of single element in a rectifier quickly and accurately, which can effectively prevent the expanding of fault and improve the repair efficiency. So it has theoretical and practical value.

Real-time open-circuit fault diagnosis method for T-type rectifiers based on median current analysis

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

A Voltage Vector Residual Estimation Method Based on Current Path Tracking for T-Type Inverter Open-Circuit Fault Diagnosis

An On-Line Fault Diagnosis Method for Power Rectifier Device Based on Fault Current Characteristic

An Average Model-Based Transistor Open-Circuit Fault Diagnosis Method for Grid- Tied Single-Phase Inverter

Online fault diagnosis method for grid-tied T-type inverters based on specific frequency calculation

Real-time Diagnosis of Multiple Transistor Open-Circuit Faults in a T-type Inverter Based on Finite-State Machine Model

Fast Transistor Open-Circuit Faults Diagnosis in Grid-Tied Three-Phase VSIs Based on Average Bridge Arm Pole-to-Pole Voltages and Error-Adaptive Thresholds

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

A Fast Average Model-Based Method for IGBT and Current Sensor Fault Diagnosis in Grid- Tied Inverters.

Fault Diagnosis Method for Neutral Grounding Three-Phase Bridge Type SSFCL

An Igbt Open-Circuit Fault Diagnosis Method For Grid-Tied T-Type Three-Level Inverters

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Fast Open-Transistor Fault Diagnosis Based On Calculated Bridge Arm Pole-To-Pole Voltages In Voltage-Source Inverters

Cascaded SAPF Fault Diagnosis Method Based on H-bridge Voltage and Current

An Online Multiple Open-Switch Fault Diagnosis Method for T-Type Three-Level Inverters Based on Multimodal Deep Residual Filter Network

A Fast Diagnosis Method for Both IGBT Faults and Current Sensor Faults in Grid-Tied Three-Phase Inverters With Two Current Sensors

A Novel Short-Circuit Fault Diagnosis Method for Three-Phase Current Source Converter

A Data-Driven Open-Circuit Fault Diagnosis Method for Three-Phase T-type Three-level Inverters

A Unified Open-Circuit-Fault Diagnosis Method for Three-Level Neutral-Point-Clamped Power Converters