Abstract:When two-phase temporary or permanent fault or three-phase temporary or permanent fault occurred in UHVAC transmission line with shunt reactor, the characteristics of differential mode current of shunt reactor in fault phase is analyzed in detail. After the three-phase tripping out at both ends of the transmission line, for temporary fault since the arc blowout at the fault point there is only the decaying periodic component in the differential mode current of shunt reactor, and for permanent fault there is only decaying DC component in the differential mode current of shunt reactor. Utilizing such a characteristic of the differential mode current of shunt reactor, it is possible to propose a new criterion that only suits to the identification of phase-to-phase fault characteristic during the three-phase adaptive reclosure, and this criterion can be realized by using the current in the shunt reactor current at one end and the moment of arc blowout can be judged as well. A lot of ATP/EMTP based simulation results show that using the proposed method the fault type can be distinguished rapidly and accurately, and basically the recognition is not affected by such factors as fault position, transition resistance, sampling frequency, load current, the moment when the fault occurred, the moment when the circuit breaker tripped out, and the moment of arc blowout at the fault point, besides, the proposed method is suitable for the transmission lines connected with shunt reactors at single end or both ends.

Fault Diagnosis Method for Neutral Grounding Three-Phase Bridge Type SSFCL

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

Control Strategy & Test Study Of Ssfcl With Bi-Directional Current

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

Fault diagnosis of power electronic circuits based on neural network and waveform analysis

Cascaded SAPF Fault Diagnosis Method Based on H-bridge Voltage and Current

A Novel Auto-transformer Coupling Bridge-type SSFCL and Its Topology Improvement

Research of fault-current limiter for three-phase four-wire power system

Research of fault current limiter based on half-controlled rectifier bridge for three-phase four-wire power system

A Unified Open-Circuit-Fault Diagnosis Method for Three-Level Neutral-Point-Clamped Power Converters

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

Identification of Permanent Faults for Three-Phase Adaptive Reclosure Based on Waveform Characteristics of Differential Mode Currents in Shunt Reactors

A New Proposal for Solid State Fault Current Limiter and Its Control Strategies

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

A Novel Six-Leg Three-Phase Fault Current Limiter

Fault Current Limiter Based on Self-Turn-Off Devices for Three-Phase Ungrounded Power Systems

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

Simulation Study of New Solid-State Fault Current Limiter