Abstract:The undesired synchronous vibration due to rotor mass imbalance is a main disturbance source in all rotating machinery including active magnetic bearing (AMB)-rotor systems. In the AMB-rotor system, imbalance compensation, which causes the AMB actuators to spin a rotor about its geometric axis, and automation balancing, which spins a rotor about its inertial axis, are two kinds of common control aim for the rotor imbalance control. In this study, the internal relation between the imbalance compensation and the automation balancing is analyzed and a uniform control method is proposed. With the identical control algorithm, the proposed control method can realize the automation balancing or the imbalance compensation, respectively, by switching the controller's junction position in the original control loop. The proposed control method does not depend on the dynamic plant model, because its algorithm is based on the real-time identification for the Fourier coefficient of the rotor imbalance disturbance. In this paper, the process of identification algorithm is given in detail and all the possible junction forms of the controller are illustrated. By the simulations, the identification performances of the control algorithm are compared in the conditions with three variable factors, including the signal noise ratio (SNR), the imbalance phase and the identification delay time. The noise level has considerable influence on the identification precision, but the imbalance phase has little. To prolong the identification delay time will be of benefit to improve the identification precision but slow down the identification process. Experiments, which are carried out on an AMB-rigid rotor test rig, indicate that by switching the junction position of the controller in control loop, both kinds of rotor imbalance control can achieve the good effectiveness. [DOI: 10.1115/1.4005279]

Repetitive Control for Vibration Suppression of Bearingless Induction Motor

Development of Bearingless Induction Motors and Key Technologies

Active Disturbance Rejection Control for Bearingless Permanent-Magnet Slice Motor Based on Nonlinear Phase-Locked Loop Observer

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Rotor Periodic Vibration Suppression for Controlled Magnetic Levitation System

A Model-Free Control Method for Synchronous Vibration of Active Magnetic Bearing Rotor System

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Suppression of Harmonic Current in Magnetic Bearing–Rotor System with Redundant Structure

Direct Displacement Control of Rotor Eccentric for Bearingless Introduction Motor

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Synchronous Disturbance Suppression of Active Magnetic Bearing Rotor Systems Using Variable Period Adaptive Control Algorithm

Implicit Generalized Predictive Control of an Active Magnetic Bearing System

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Active Control for Unbalanced Vibration Control of Electric Spindle-Tool System