Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Rotor Periodic Vibration Suppression for Controlled Magnetic Levitation System

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Vibration of Flexible Rotor Systems with Two-Degree-Of-Freedom Pid Controller of Active Magnetic Bearings

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Active Control of Active Magnetic Bearings for Maglev Flywheel Rotor System Based on Sliding Mode Control

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Frequency-doubling Displacement Disturbance Suppression of Active Magnetic Bearing Based on Repetitive Control

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

The Effect of Controllers on the Dynamic Behaviour of a Rotor Supported on Active Magnetic Bearings

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Harmonic Vibration Suppression of AMB Rotor Based on VSS Repetitive Controller Considering Mass Imbalance and Sensor Runout

The Influence of PID Controller Parameters on Polarity Switching Control for Unbalance Compensation of Active Magnetic Bearings Rotor Systems

Robust Proportional-Differential Control Via Eigenstructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Study on Inverter-fed Three-pole Active Magnetic Bearing