Abstract:The miniaturization of electronic devices brings severe challenges in the deposition of metal interconnects in back end of line processing due to a continually decreasing volume available for metal deposition in the interconnect via. Cu is currently used as the interconnect metal and requires barrier and liner layers to prevent diffusion into silicon and promote deposition of smooth conducting metal films, respectively. However, these take up a significant volume in the interconnect vias, which are already extremely narrow due to the high aspect ratio required. Designing combined barrier/liner materials provides opportunities to promote deposition of smooth films and avoid islanding and frees up precious volume to deposit the required amount of interconnect metal. We present here the first atomistic kinetic Monte Carlo (kMC) investigation of the potential of Ru-modified TaN as a dual-function barrier/line material to promote 2D morphology of deposited Cu enabling optimization of the limited available interconnect volume. The kMC simulations use Density Functional Theory (DFT) activation barriers to predict the role of the combined barrier/liner material on the morphology of deposited Cu and give, for the first time, a tool to predict metal deposition on technologically important substrates. We study Cu deposition at different partial pressures on a series of substrates, including unmodified TaN and TaN with 25% or 50% surface Ru incorporation, at deposition temperatures of 300 K, 500 K and 800 K. The deposition simulations predict Cu film roughness, island size and number, substrate exposure area (as a measure of 2D vs. 3D morphology), layer occupation rate, compactness (as a measure of film quality) and the impact of annealing. As-deposited Cu on unmodified TaN exhibits significantly higher roughness and substrate exposure areas, demonstrating island formation...

CuTi as Potential Liner-and Barrier-Free Interconnect Conductor

Study on interface behavior of Be/CuCrZr alloy by diffusion bonding

First-principles investigation of Cu/Ti-TM/Si (TM=W, Ru) interfaces: Role of Ti-TM binary alloys as diffusion barrier layers

Evaluation of the thermal stability of TiW/Cu heterojunctions using a combined SXPS and HAXPES approach

Low-Resistivity Ru-Ta-C Barriers for Cu Interconnects

Recent Advances in Barrier Layer of Cu Interconnects

Ti and NiPt/Ti Liner Silicide Contacts for Advanced Technologies

Sputtered Ru–Ti, Ru–N and Ru–Ti–N Films As Cu Diffusion Barrier

Electroless Cu Deposition Process on TiN for ULSI Interconnect Fabrication Via Pd/Sn Colloid Activation

Amorphous-like TiN Films as Barrier Layers for Copper

Interfacial Characterization of Low-Temperature Cu-to-Cu Direct Bonding with Chemical Mechanical Planarized Nanotwinned Cu Films

Ru/TaSiN with different Ta/Si atomic ratio as barrier for Cu contact on NiSi substrate

Ultrathin Ru–Ta–C Barriers for Cu Metallization

Investigative characterization of delamination at TiW-Cu interface in low-temperature bonded interconnects

Control of Cu morphology on TaN barrier and combined Ru-TaN barrier/liner substrates for nanoscale interconnects from atomistic kinetic Monte Carlo simulations

Improvement of interfacial adhesion strength and thermal stability of cu/cap barrier/low-k dielectric stack by plasma treatment on the surface of Cu film

Failure Mechanism of 5 Nm Thick Ta–Si–C Barrier Layers Against Cu Penetration at 750–800°C

Ultra-Thin Ru/TaN Bi-Layer as Diffusion Barrier to Seedless Copper Interconnect

Cu Contact on NiSi/Si with a Ru/TaN Barrier Stack

Cu Contact on NiSi/Si with Thin Ru/TaN Barrier

Ti–Cu Coatings Deposited by a Combination of HiPIMS and DC Magnetron Sputtering: The Role of Vacuum Annealing on Cu Diffusion, Microstructure, and Corrosion Resistance