Abstract:High-power pulsed magnetron sputtering (HiPIMS) can produce high density and high adhesion coatings due to the high ionization. However, industrial application of HiPIMS is limited because of the unstable discharge and small deposition rate. A cylindrical cathode, developed on the basis of hollow cathode effect, can improve the discharge stability. With the development of electromagnetic systems, the plasma transport is improved, and thus increasing the deposition rate significantly. However, the introduction of electromagnetic system leads the strong discharge and large etching area on the target to be incompatibly controlled. In this work, the distribution of the tangential and longitudinal magnetic field on the target surface are improved by adding external magnets, and their effects on the plasma discharge are studied. By optimizing the magnets, the tangential magnetic field on the target surface becomes stronger and more uniform. Meanwhile, the peak of the longitudinal magnetic field increases from 73 to 96 mT and the peak location expands to two-sides of the cathode. The simulation result shows that the target etching area described by the proportion of the target area with the tangential magnetic field intensity higher than 40 mT increases from 51% to 67%, and the HiPIMS discharge studied by the particle in cell/Monte Carlo collision (PIC/MCC) method and plasma global model shows that the ion current and spectral intensity are significantly enhanced, exhibiting a doubled Cr density of 2.6 x 1020 m-3 and an increased ionization from 90% to 92.1%. The practical Ar/Cr HiPIMS discharge is carried out separately with the original and optimized cylindrical cathode, and the results reveal that the brightness of plasma glow, the target current and the etching area all increase after the improvement. Furthermore, the ion current and the optical emission spectrum suggest that the flux of ions arriving at the substrate is approximately doubled, which means that an about doubled deposition rate of the optimized cathode is achievable.

Effect of target grain size on target sputter etching morphology and performance

Influence of grain size of Cu target on its magnetron sputtering erosion and parameters

Comprehensive effect of grain size and original target morphology on sputtering behavior of magnetron sputtering target

Effects of grain size, dislocation density, and texture type on the etching behavior of Cu target in magnetron sputtering process

Effect of Grain Size on Corrosion of Nanocrystalline Copper in NaOH Solution

The Effect of Ion Current Density on Target Etching in Radio Frequency-Magnetron Sputtering Process

Discharge and Deposition Characteristics of High-Power Impulse Magnetron Sputtering Using Various Target Materials

Performance of a Planar Magnetron Sputtering Apparatus with Complex Targets

Size Effects on the Impact Response of Copper Nanobeams

Effect of grain size and crystal orientation on the corrosion behavior of as-extruded Mg-6Gd-2Y-0.2Zr alloy

Correlation Between the Formation of Particle Defects on Sputtered Cu Seed Layers and Cu Targets

Study of ion sputtering on AlxSn100-x alloy system

Effects of Target Quality on Electrical Performance and Stability of In-Sn-Zn-O Thin-Film Transistors

The Effect of Sputtering Target Density on the Crystal and Electronic Structure of Epitaxial BaTiO3 Thin Films

Effects of grain size of AISI 304 on the machining performances in micro electrical discharge machining

Research on correlation between metal oxide semiconductor target and magnetron sputtered film based on TFT application

Influence of Target Current on Structure and Performance of Cu Films Deposited by Oscillating Pulse Magnetron Sputtering

Effects of Substrate Geometry on Performance of Twin-Fluid Atomizer in Metal Powder Production

Influence of Etchants on Etched Surfaces of High-Strength and High-Conductivity Cu Alloy of Different Processing States

Magnetic Field Optimization and High-Power Discharge Characteristics of Cylindrical Sputtering Cathode