Abstract:The efficiency of a thermoelectric (TE) generator for the conversion of thermal energy into electrical energy can be easily but roughly estimated using a constant properties model (CPM) developed by Ioffe. However, material properties are, in general, temperature (T)-dependent and the CPM yields meaningful estimates only if physically appropriate averages, i.e., spatial averages for thermal and electrical resistivities and the temperature average (TAv) for the Seebeck coefficient (α), are used. Even though the use of αTAv compensates for the absence of Thomson heat in the CPM in the overall heat balance, we find that the CPM still overestimates performance (e.g., by up to 6% for PbTe) for many materials. The deviation originates from an asymmetric distribution of internally released Joule heat to either side of the TE leg and the distribution of internally released Thomson heat between the hot and cold side. The Thomson heat distribution differs from a complete compensation of the corresponding Peltier heat balance in the CPM. Both effects are estimated quantitatively here, showing that both may reach the same order of magnitude, but which one dominates varies from case to case, depending on the specific temperature characteristics of the thermoelectric properties. The role of the Thomson heat distribution is illustrated by a discussion of the transport entropy flow based on the α(T) plot. The changes in the lateral distribution of the internal heat lead to a difference in the heat input, the optimum current and thus of the efficiency of the CPM compared to the real case, while the estimate of generated power at maximum efficiency remains less affected as it is bound to the deviation of the optimum current, which is mostly <1%. This deviation can be corrected to a large extent by estimating the lateral Thomson heat distribution and the asymmetry of the Joule heat distribution. A simple guiding rule for the former is found.

Principle of determining thermoelectric properties based on I–V curves

Voltage–Current Curves to Characterize Thermoelectric Generators

First-Principles Thermodynamic Theory of Seebeck Coefficients

Measurement and Analysis for Performance of Micro-thermoelectric Generator

A Self-Heating 2ω Method for Seebeck Coefficient Measurement of Thermoelectric Materials.

Thermoelectric Module Design Under a Given Thermal Input: Theory and Example

Three-wire Method to Characterize the Thermoelectric Properties of One-Dimensional Materials

Measurement of electrical resistance of thermoelectric materials with a temperature gradient using instant load-voltage analysis

Thermoelectrical potential and derivation of Kelvin relation for thermoelectric materials

Thomson/Joule Power Compensation and the Measurement of the Thomson Coefficient

Precise measurement of absolute Seebeck coefficient from Thomson effect using ac-dc technique

An in-situ thermoelectric measurement apparatus inside a thermal-evaporator

Equivalent parameters for series thermoelectrics

Novel principle for characterizing the material-level parameters of a thermoelectric generator module

The thermoelectric conversion efficiency problem: Insights from the electron gas thermodynamics close to a phase transition

Co-In-Sb Ternary System (II): Isoplethal Section and Thermodynamic Modeling

A New Laser-Combined H-Type Device Method for Comprehensive Thermoelectrical Properties Characterization of Two-Dimensional Materials

Toward thermoelectric characterization of (nano)materials by in situ transmission electron microscopy

Comparison of Predicted Thermoelectric Energy Conversion Efficiency by Cumulative Properties and Reduced Variables Approaches

Discrepancy between Constant Properties Model and Temperature-Dependent Material Properties for Performance Estimation of Thermoelectric Generators

THERMOELECTRIC MONITORING OF THERMAL RESISTANCE IN ELECTRONIC SYSTEMS