Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

The mechanism of oxidational wear

Formation and wear mechanism of tribo-oxides and the regime of oxidational wear of steel

The relevance of wear-mechanism maps to mild-oxidational wear

Research on oxidation wear mechanism of the cast steels

Characteristics of the Worn Surface of Magnetized Sliding Contact Medium Carbon Steel/Medium Carbon Steel

Fundamental wear mechanism of metals

Tribological mechanisms of slurry abrasive wear

High diffusivity pathways govern massively enhanced oxidation during tribological sliding

Investigation on the effect mechanism of oxidation on the tribological performance of cast steel /copper matrix composite

The evolution mechanism of tribo-oxide layer during high temperature dry sliding wear for nickel-based superalloy

Mechanisms of abrasive wear in lubricated contacts

An experimental investigation of adhesive wear extension in fretting interface: application of the contact oxygenation concept

Wear and Contact Temperature Evolution in Pin-on-Disc Tribotesting of Low-Metallic Friction Material Sliding Against Pearlitic Cast Iron

Ti6Al4V interacting with Al 2 O 3 under Ambient and Vacuum Conditions: Effect of Plastic Deformation and Tribo-Chemical Reactions on Wear Mechanisms

Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle Size

Wear and damage transitions of two kinds of wheel materials in the rolling-sliding contact

An examination of a mild wear process

Microstructure Evolution and Fretting Wear Mechanisms of Steels Undergoing Oscillatory Sliding Contact in Dry Atmosphere

Prediction of wear volume and friction coefficients of SS304 alloy using grey taguchi based response surface methodology

Friction and wear of titanium alloys sliding against metal, polymer, and ceramic counterfaces

Correlation between the characteristics of the thermo-mechanical mixed layer and wear behaviour of Ti–6Al–4V alloy