Abstract:Copper/graphite composites have received much attention in engineering applications due to their excellent thermal, electrical and self-lubricating properties. However, their mechanical and wear resistance properties are usually limited by the brittleness of graphite and the poor interfacial bond between graphite and copper. Harder particles can be used to reinforce composites to increase their mechanical properties and wear resistance. In this paper, copper/graphite composites added with Ti3AlC2 particles were prepared by rapid hot press sintering. Studies were conducted to find out how the sintering temperature affected the composites' phase composition, morphology, hardness, relative density, and friction properties. The results showed that the relative density and hardness of the composites increased and then decreased with increasing sintering temperature. Besides, the findings indicated that Al atoms started to diffuse out of Ti3AlC2 and into the Cu matrix around 800 °C, leading to the in-situ formation of TiCx and Cu(Al) alloys. When the sintering temperature exceeded 850 °C, Ti3AlC2 decomposed essentially completely. In comparison to other similar prior findings (the wear rate was ∼1 ×10−4 mm3·N−1·m−1), the copper/graphite composites prepared in this work shown improved wear resistance. Among them, the lowest wear rate (1.942 × 10−5 mm3·N−1·m−1) was obtained at a sintering temperature of 900 °C, with a relative density of 98.41%, a hardness of 75.67 HV and an average coefficient of friction of 0.15. This will help to further broaden the application areas of copper/graphite composites.

Investigation on the effect mechanism of oxidation on the tribological performance of cast steel /copper matrix composite

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

Tribological behavior of modified polyetheretherketone composites in sliding against stainless steel under water lubrication

Research on oxidation wear mechanism of the cast steels

Investigation on tribological behaviour of copper-free composite friction material under dry sliding at high-temperature

Tribological Behavior and Wear Mechanism of Cu-SiO2 Sintered Composite under Different Sliding Speeds

Tribological properties of copper-matrix composites against laser-cladded Co06 coating on 30CrMoSiVA steel at elevated temperatures

Effect of Type and Content of Iron Powder on the Formation of Oxidized Film and Tribological Properties of Cu-matrix Composites

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

High-Temperature Friction and Wear Behavior of Nickel-Alloy Matrix Composites with the Addition of Molybdate

Study on the oxidation behaviours and the interactions between friction and oxidation of the Ni-based composites with in-situ carbides reinforcement at 800 °C

Study on the Tribology Properties of the Particles/Cu Composite Coatings

Properties and elevated temperature wear mechanism of pure copper and TiC/Cu nanocomposites

Effect of sintering temperature on microstructure and tribological properties of copper/graphite composites doped with Ti3AlC2 particles

High temperature tribological behaviors and wear mechanisms of NiAl-MoO3/CuO composite coatings

Tribology performance of Cu-C/C composites with and without current

Tribological behaviors of vacuum hot-pressed ceramic composites with enhanced cyclic oxidation and corrosion resistance

Effect of Heat Treatment on Tribological Properties of SiCp/Al–Mg–Mn–Cu Aluminum Matrix Composites

Formation and wear mechanism of tribo-oxides and the regime of oxidational wear of steel

Effect of Cu content on high-temperature tribological properties and oxidation behavior of Al-Ti-V-Cu-N coatings deposited by HIPIMS

Effect of the Thermal Expansion Characteristics of Reinforcements on the Electrical Wear Performance of Copper Matrix Composite