Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

The comparative transient prediction on hydrodynamic characteristics and flow field properties of pump-jets with accelerating and decelerating ducts

Effect of Taper Angle on the Performance of Jet Pumps for a Loop-Structured Thermoacoustic Engine

Numerical Analysis of the Influence of Hull-Modulated Inflow on Unsteady Force Fluctuations and Vortex Dynamics of Pump-Jet Propulsor

Investigations into the unsteady internal flow characteristics for a waterjet propulsion system at different cruising speeds

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Design Method of Water Jet Pump Towards High Cavitation Performances

Experimental and numerical investigations into flow features in an intake duct for the waterjet propulsion under mooring conditions

Numerical Design Study of Duct and Stator for a Pump-Jet Propulsor

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

Numerical study on transient hydraulic excitation force characteristics of a water jet mixed-flow pump during rapid startup period

Hydrodynamic Design of an Advanced Submerged Propulsion

Wake flow characteristics and unsteady performance of a pump-jet propulsor under hull condition

Numerical Investigation on Transient Flow of A High Head Low Specific Speed Pump-Turbine in Pump Mode

Numerical Investigations of the Energy Performance and Pressure Fluctuations for a Waterjet Pump in a Non-Uniform Inflow

Research on the Internal Flow Difference between Peak and Valley Conditions of Water Jet Propulsion Pump during Working at Hump Region

Numerical Study on the Stall Behavior of a Water Jet Mixed-Flow Pump

Broadband Force Spectra of a Pump-Jet Propulsor Subjected to Inflow Turbulence: Comparison with Ducted Propeller and Propeller

Experimental and Numerical Study of Transient Flow in a Centrifugal Pump During Startup

Sources and mechanisms of flow loss and hydroacoustics in a pre-swirl stator pump-jet propulsor

Analysis of flow in liquid jet pump—Part Ⅰ:Experiment and three-dimension numerical simulation