Analysis of flow in liquid jet pump—Part Ⅰ:Experiment and three-dimension numerical simulation

Wang Songlin,Wang Yuchuan,Gui Shaobo,Gao Chuanchang,Cao Shuliang
DOI: https://doi.org/10.3969/j.issn.1674-8530.2012.06.008
2012-01-01
Abstract:The performance of a horizontally installed liquid jet pump with side suction was tested and its internal flow was analyzed by numerical simulation.The standard k-ε two-equation turbulence model and SIMPLE method were adopted in the numerical simulations.The simulated performance parameters agreed well with experimental ones at the best efficiency point.Two-fluid mixing process and its flow pattern in the pump were analyzed as well based on the numerical simulation results.At a large flow ratio(q>0.8),a reduced local pressure ratio and the suctioned liquid with loss of energy are observed in the region from throat inlet to 0.6 times the throat diameter down stream due to mixing and local frictional losses.As the flow ratio increases,the energy obtained by the suction fluid is decreased,thus the distance where an energy transfer takes place between two fluids increases;the two fluids velocity becomes uniform once the suctioned liquid travels in the nozzle for a distance as long as 6-8 times the throat diameter.However,the peak pressure occurs in less than that distance.Such a two liquid mixing process in the throat is similar to that of fully developed turbulent flow.For the side suction jet pump,there are vortexes in the cross-section induced by a secondary flow due to asymmetric flow in the suction chamber,but the velocity of the secondary flow is so smaller than the mainstream velocity in the throat that the major characteristics of the jet pump can be obtained by a two dimensio-nal theoretical analysis.
What problem does this paper attempt to address?