Abstract:Unsteady cavitating turbulent flow simulations need to be responsible for both cavitation and turbulence modeling issues. The Partially-Averaged Navier–Stokes (PANS) computational model developed from the RANS method and the k–ε turbulence model are used to model turbulent cavitating flow with a mass transfer cavitation model in the present paper. An objective of this study is to pursue more accurate estimates of unsteady cavitating flows with large-scale fluctuations at a reasonable cost. Firstly, the unsteady cavitating flow simulations over a NACA66-mod hydrofoil are performed using the PANS method with various values of the resolution control parameters (fk=1∼0.2, fε=1) to evaluate the numerical methods based on experimental data. The comparison with the experiments show that the numerical analysis with a fk=0.2 can predict the cavity evolution and shedding frequency fairly well. Then, cavitating flow around a marine propeller in non-uniform wake was simulated by PANS method. The calculations show that large cavity volume pulsation as the blade passes through the wake region is resolved better by the PANS method with fk=0.2 than by the RANS method with the k–ε or k–ω SST turbulence models. This can be contributed to the fact that a smaller fk give larger cavity volume pulsations leading to increased cavity volume accelerations and larger pressure fluctuations above the propeller, while a larger fk overestimates the turbulent viscosity along the rear part of the cavity. Finally, it is confirmed from the simulation by the PANS method with fk=0.2 that the whole process of cavitating flow evolution around the propeller in non-uniform wake can be very well reproduced including cavitation inception, sheet cavitation and tip vortex cavitation observed experimentally.

Comparison of the hydrodynamic performance of front and rear-stator pump-jet propulsors in an oblique wake under the cavitation condition

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Design Method of Water Jet Pump Towards High Cavitation Performances

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

Wake flow characteristics and unsteady performance of a pump-jet propulsor under hull condition

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Energy Contribution Study of Blade Cavitation Control by Obstacles in A Waterjet Pump Based on Mpod and EEMD

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical study of the hydrodynamic performances of surface piercing propeller

Numerical Design Study of Duct and Stator for a Pump-Jet Propulsor

Partially-Averaged Navier-Stokes method with modified k-ε model for cavitating flow around a marine propeller in a non-uniform wake

Experimental and Numerical Investigation of the Impacts of Rotor Tip-Rake on Excitation Forces of Pump-Jet Propulsors

Numerical Analysis of the Influence of Hull-Modulated Inflow on Unsteady Force Fluctuations and Vortex Dynamics of Pump-Jet Propulsor

Experimental and numerical study on cavitation pulsating pressure of water-jet propulsion axial-flow pump

Sources and mechanisms of flow loss and hydroacoustics in a pre-swirl stator pump-jet propulsor

Numerical Study on the Stall Behavior of a Water Jet Mixed-Flow Pump

Numerical Study of Cavitating Turbulent Flow Around Propellers: Relationship of Cavity Volume Evolution and Pressure Fluctuation

Effect of pre-swirl stator angles on broadband noise considering hydrodynamic performance of pump-jet propeller

Excitation force on a pump-jet propeller: The clocking effect of pre-swirl stator

Numerical Investigation of Tip Geometry on the Tip-clearance Flow Features of a Pump-jet Propulsor

Unsteady Numerical Simulation of Cavitating Turbulent Flow Around A Highly Skewed Model Marine Propeller