Abstract:To study the safety and stability of the main truss arch structure during the concrete pouring process in a long-span CFST arch bridge, a combination of theoretical analysis and numerical simulation was adopted. The world's longest span CFST arch bridge, the Pingnan Third Bridge (main span 575 m) in Guangxi Province, was taken as an example. Firstly, the basic theory of stability and the concrete pouring technology of the main truss arch structure were summarized. Secondly, a three-dimensional finite element model of the main truss arch structure was established for the concrete pouring stage. Finally, the linearity, stress, and stability of the main truss arch structure during concrete pouring were studied. The results show that both vertical and transverse deflections occurred in the main truss arch structure during concrete pouring from the arch foot to the arch vault; the upper and transverse deflections of the main truss arch structure showed parabolic changes, and the upper and transverse deflections of the midspan section were larger than those of other sections. When concrete was poured near the 1/6 section of the main truss arch structure, the upper and transverse deflections of the middle section of the main truss arch structure peaked; the maximum upper deflection reached 113 mm, and the maximum transverse deflection reached 60 mm. In the process of concrete pouring from the arch foot to the arch vault, the stress in the steel tubes and concrete was constantly changing. Although upper and transverse deflections of the main truss arch structure occurred during concrete pouring, the stress in the steel tube and concrete in the main truss arch structure did not exceed the tensile strength, and the linearity of the main truss arch could be adjusted by retaining the anchor cables, which were set in the erection stage of the main truss arch structure at the 1/6 section of the main truss arch structure. During the concrete pouring process of the various steel tubes of the main truss arch structure, the stability coefficients of the main truss arch structures decreased gradually. During concrete pouring in a single steel tube, the maximum reduction in the stability factor was 21.32%, which occurred in the 1# steel tube, and the minimum decrease in the stability factor was 8.89%, which occurred in the 8# steel tube. The stability coefficients were greater than 4 after this reduction and met the requirements of the design specifications. This study can provide a reference for the optimization design and construction monitoring of long-span CFST arch bridges.

Research Progress on Post Cast Strip Construction Technology of Super Long Concrete Structure

STUDY ON APPLICATION OF CONCRETE FILLED PRESTRESSING STEEL TUBULAR STRUCTURE

Effects of controlled permeability formwork on surface properties and early age shrinkage of concrete

Prestressed Concrete Design Method for Large-scale Continuous Basement with Shrinking Effect

Research on shrinkage control technology of lightweight ultra-high performance concrete

Research on Spatial Effect of Prestressing Force in Long-Span Concrete Bridge

Research And Application On Performance-Based Optimization Of Concrete Structure Construction

Some Key Problems Of High Performance Fiber Reinforced Concrete Submerged Floating Tunnel

Experimental Study on Waterproofing Properties of Putty-Based Composite Rubber Strip for Underground Post-Tensioned Precast Concrete Structures

Study on the safety of the concrete pouring process for the main truss arch structure in a long-span concrete-filled steel tube arch bridge

Experimental Study on Effects of Casting Procedures on Compressive Strength, Water Permeability, and Interfacial Transition Zone Porosity of Rock-Filled Concrete

Discussion on construction technology of cast-in-place beam and plate of multistory frame structure

Technical Advances of Temporary Facilities for the Failure Prevention of Large-Span Cantilever Casting Construction of Mountainous Concrete Box-Type Arch Bridges

Experimental Study on Bond and Anchorage of Steel Bars in Precast Concrete Structures with New-to-old Concrete Interface

Casting Simulation of Large-Volume Fluid Cementitious Materials: Effect of Material Properties and Casting Parameters

Restrained Shrinkage of Intermittent Casting Concrete Slab in the Early Age

The Study on Early-Age Expansion and Shrinkage Model of Massive Self-Compacting Concrete Pumped in Steel Tube Column

Research on asphalt concrete pavement construction technology for long span steel bridge deck

Multiscale Performance Characterization of Concrete Formed by Controlled Permeability Formwork Liner

LESSONS OF REMOVING FORMWORK AHEAD OF TIME UNDER THE CONSTRUCTION OF POST-CAST STRIP IN RC STRUCTURES

Research on Prefabricated Open Caisson Construction Technology