Abstract:The general dispersion theory of Aris is applied to predict the virtual asymptotic dispersion behavior of packed columns. The derived model is also used to estimate the actual pre-asymptotic dispersion behavior of modern 2.1 mm × 50 mm columns packed with sub-2 μm fully porous particles (FPPs) during the transient dispersion regime. The model accounts for the actual radial distribution of the flow velocity across the column diameter. From the wall to the center of the column, focused-ion-beam scanning electron microscopy (FIB-SEM) experiments were recently performed to reveal the existence of a thin (0.15dp wide, dp is the average particle diameter) hydrodynamic boundary layer (THBL), a thin (3dp wide) and loose orderly packed layer (TLOPL), a 60dp wide and dense randomly packed layer (WDRPL), and a large (≃460dp) randomly packed bulk central region [1]. The theoretical calculations of the actual pre-asymptotic reduced van Deemter curves (2.1 mm × 50 mm column, sub-2 μm BEH-C18 FPPs, n-hexanophenone analyte, acetonitrile/water eluent, 80/20, v/v, flow rate from 0.05 to 0.35 mL/min) confirm that the impact of the sole THBL on column dispersion can be neglected. In contrast, the contribution of the TLOPL to the reduced plate height (RPH) is about 0.2 h unit at optimum reduced velocity. Most remarkably, the negative impact of the TLOPL on column performance may be fully compensated by the presence of the adjacent WDRPL if the depth of the velocity well were to be 5% of the bulk velocity. In actual 2.1 mm × 50 mm columns packed with sub-2 μm FPPs, this velocity depth is as large as 25% of the bulk velocity causing a significant RPH deviation of 0.7 h unit from the RPH of the bulk packing free from wall effects. Maximum column performance is expected for a reduction of WDRPL density. This suggests optimizing the packing process by finding the proper balance between the stress gradient across the WDRPL (responsible for the deep velocity well) and the friction forces between the packed particles (responsible for the rearrangement of the particles during bed consolidation). Past and recently reported RPH data support the theoretical insights: the stress gradient/particle friction balance in the WDRPL is better realized when packing superficially porous particles (SPPs) rather than FPPs in 2.1-4.6 mm i.d. columns (the RPH deviation is reduced to 0.4 h unit) or sub-2 μm particles in 100 cm × 75 μm i.d. capillaries combining high slurry concentrations and sonication (the RPH deviation is reduced to only 0.15 h unit).

Experimental studies of dispersed phase axial dispersion in pulsed sieve plate columns

Evaluation and Characterization of Axial Distribution in Expanded Bed: II. Liquid Mixing and Local Effective Axial Dispersion

NONUNIFORM HYDRODYNAMICS AND AXIAL DISPERSION BEHAVIORS IN EXPANDED BEDS

Variation of the Axial Dispersion along the Bed Height for Adsorbents with a Density Difference and a Log-Normal Size Distribution in an Expanded Bed

Variation of the Local Effective Axial Dispersion Coefficient with Bed Height in Expanded Beds

Determining Axial Dispersion Coefficients of Pilot-Scale Annular Pulsed Disc and Doughnut Columns

Mass transfer and axial mixing characteristics in a coalescence-dispersion pulsed-sieve-plate extraction column

Dispersed Phase Holdup in a Tall and Low Plate Free Area Liquid Pulsed Sieve-Plate Extraction Column

Hydrodynamics of a Pulsed Sieve Plate Extraction Column

Estimation of Axial Dispersion in Pulsed-Plate Extraction Columns

CFD Simulation of Liquid–Liquid Two-Phase Hydrodynamics and Axial Dispersion Analysis for a Non-Pulsed Disc and Doughnut Solvent Extraction Column

Mass transfer performance in a coalescence–dispersion pulsed sieve plate extraction column

Axial Mixing and Mass Transfer Characteristics of Pulsed Extraction Column with Discs and Doughnuts

An Experimental Study of Immiscible Liquid–liquid Dispersions in a Pump–mixer of Mixer–settler

On the relationship between radial structure heterogeneities and efficiency of chromatographic columns

Effect of Sieve Plate Arrangement on Mass Transfer Performance of Pulsed-Sieve-Plate Extraction Column

CFD Simulation of Two-Phase Flow in a Hybrid Pulsed Sieve-Plate Solvent Extraction Column: Prediction of Holdup and Axial-dispersion Coefficients

Dispersion in retentive pillar array columns

Dispersion of solute in a packed cylindrical tube with wall reaction

Effect of solvent properties on the dispersion coefficient in an on-line microwave flow-injection system

Dispersion in flow through porous media—II. Two-phase flow