Abstract:The accurate prediction of the droplet size distribution (DSD) in liquid–liquid turbulent dispersions is of fundamental importance in many industrial applications and it requires suitable kernels in the population balance model. When a surfactant is included in liquid–liquid dispersions, the droplet breakup behavior will change as an effect of the reduction of the interfacial tension. Moreover, also the dynamic interfacial tension may be different with respect to the static, due to the fact that the surfactant may be easily desorbed from the droplet surface, generating additional disruptive stresses. In this work, the performance of five breakup kernels from the literature is assessed, to investigate their ability to predict the time evolution of the DSD and of the mean Sauter diameter, when different surfactants are employed. Simulations are performed with the Quadrature Method of Moments for the solution of the population balance model coupled with the two-fluid model implemented in the compressibleTwoPhaseEulerFoam solver of the open-source computational fluid dynamics (CFD) code OpenFOAM v. 2.2.x. The time evolution of the mean Sauter diameter predicted by these kernels is validated against experimental data for six test cases referring to a stirred tank with different types of surfactants (Tween 20 and PVA 88%) at different concentrations operating under different stirrer rates. Our results show that for the dispersion containing Tween 20 additional stress is generated, the multifractal breakup kernel properly predicts the DSD evolution, whereas two other kernels predict too fast breakup of droplets covered by adsorbed PVA. Kernels derived originally for bubbles completely fail.

An Experimental Study of Immiscible Liquid–liquid Dispersions in a Pump–mixer of Mixer–settler

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Droplet Velocity, Size, and Local Holdup Measurements in an Extraction Column by Tri-Sensor Optical Probe

A Study on Liquid‐liquid Dispersions in a Continuous Mixer Via Computational Fluid Dynamics (CFD) Simulation Combined with Population Balance Model (PBM)

A Study on Hydrodynamic Characteristics in a Φ38 Pulsed Extraction Column by Four‐sensor Optical Fiber Probe

A new method to quantify droplet size distribution based on Monte Carlo simulation in liquid–liquid solvent extraction

CFD Simulation of Immiscible Liquid-Liquid Dispersion in a Stirred Tank

Study on mixing and settling characteristics in mixer-settler

Liquid–liquid micro-dispersion in a double-pore T-shaped microfluidic device

Liquid–liquid Extraction Based on Droplet Flow in a Vertical Microchannel

Experimental study on the dispersed phase macro-mixing in an immiscible liquid–liquid stirred reactor

Investigation of Droplet Breakup in Liquid–liquid Dispersions by CFD–PBM Simulations: the Influence of the Surfactant Type

Droplet Formation Regime and Size Prediction in Substantial Mass Transfer Systems

Drop size model in oil-water dispersed flows

Measurement of Drop Size in Liquid-Liquid Two-Phase Flow by Dual Optical Probe Technology

Measurement and analysis of bimodal drop size distribution in a rotor-stator homogenizer

Numerical Investigation of Droplet Pre-Dispersion in a Monodisperse Droplet Spray Dryer

Preparation of Microdispersed Droplets by Phase Inversion in Gas/liquid/liquid Microdispersion System

INVESTIGATION ON DISPERSED PHASE HOLDUP AND FLOODING VELOCITY OF AGITATING EXTRACTION COLUMN

Experimental Investigation of Droplet Formation Mechanisms by Electrostatic Dispersion in a Liquid-Liquid System

Study on Droplet Velocity in a Pulsed Sieve Plate Extraction Column by Four-Sensor Optical Fiber Probe