Abstract:Ignition delay times are obtained for kerosene/air mixtures behind the reflected shock waves at temperatures between 1445 and 1650 K, at a pressure of 0.11 MPa and an equivalence ratio of 1.0. A nebulization device with Laval nozzle is used to nebulize kerosene and form an aerosol phase, which evaporates and diffuses rapidly behind the incident shock waves. Mixtures auto-ignite behind the reflected shock waves. An ICCD is used to visualize the kerosene/air mixture’s ignition characteristics. The mixture’s ignition intensity increases with increase in initial temperature. Continuous and irregular flames exist below 1515 K while plane and discontinuous flames exist over 1560 K. Ignition delay times decrease with increase in initial temperature. Experimental data shows good agreement with results reported previously in the literature. A new surrogate (consisting of 10% toluene, 10% ethylbenzene and 80% n-decane) is proposed for kerosene. Honnet et al.’s mechanism is used to simulate the ignition of kerosene with calculations agreeing well with the experimental data. The sensitivity of reaction H+O2⇔OH+O, which shows the highest sensitivity to the ignition delay time, increases with an increase in temperature. The chain breaching reaction of CH3 with O2 accelerates the total reaction rate and the H-atom abstraction of n-decane controls the total reaction rate. The rate of production and instantaneous heat production indicate that two reactions, H+O2⇔OH+O and O+H2⇔OH+H, are the key reactions to the formation of OH radicals, as well as the main endothermic reaction. However, the reaction of R3 is the main heat release reaction during ignition. Flame structure analysis shows that initial pressure is increased slightly as CO and H2O will appear before main ignition.

Experimental Study of the Ignition of a Stoichiometric Propylene–Oxygen–Argon Mixture Behind a Reflected Shock Wave

An experimental and kinetic modeling study of the autoignition of syngas mixtures behind reflected shock waves

Shock Tube Study on Auto-Ignition Characteristics of Kerosene/air Mixtures

Study on Ignition Delay of Kerosene Aerosol in Shock Tube

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

Shock Tube Study on Auto-ignition Delay of Kerosene Aerosol and its Cracked Mixture

Shock Tube Study of Methylcyclohexane Ignition over a Wide Range of Pressure and Temperature

Shock tube and modeling study of ignition delay times of propane under O2/CO2/Ar atmosphere

Ignition Delay Times of Kerosene (Jet-A)/Air Mixtures

Direct Observations of Reaction Zone Structure in Shock-Induced Ignition of Methane Air Mixture

Ignition Delay-Time Behind Reflected Shock Waves of Small Hydrocarbons–nitrous Oxide(–oxygen) Mixtures

Ignition Delay Times of Ethane under O2/CO2 Atmosphere at Different Pressures by Shock Tube and Simulation Methods

Ignition delay of lean hydrogen-air mixtures

Ethylene Oxidation Experimental Study and Kinetic Mechanism Analysis Based on Shock Tube

Shock Tube Measurement of Ethylene Ignition Delay Time and Molecular Collision Theory Analysis

Experimental and modeling study of the autoignition of cyclopentane

Experimental and modeling study on ignition delays of lean mixtures of methane, hydrogen, oxygen, and argon at elevated pressures

Aerosol Shock Tube Designed for Ignition Delay Time Measurements of Low-Vapor-Pressure Fuels and Auto-Ignition Flow-Field Visualization

The ignition delay measurement of atomized kerosene air mixture in an aerosol shock tube

Investigation of Methanol Ignition Phenomena Using a Rapid Compression Machine