Abstract:Ignition delay times are obtained for kerosene/air mixtures behind the reflected shock waves at temperatures between 1445 and 1650 K, at a pressure of 0.11 MPa and an equivalence ratio of 1.0. A nebulization device with Laval nozzle is used to nebulize kerosene and form an aerosol phase, which evaporates and diffuses rapidly behind the incident shock waves. Mixtures auto-ignite behind the reflected shock waves. An ICCD is used to visualize the kerosene/air mixture’s ignition characteristics. The mixture’s ignition intensity increases with increase in initial temperature. Continuous and irregular flames exist below 1515 K while plane and discontinuous flames exist over 1560 K. Ignition delay times decrease with increase in initial temperature. Experimental data shows good agreement with results reported previously in the literature. A new surrogate (consisting of 10% toluene, 10% ethylbenzene and 80% n-decane) is proposed for kerosene. Honnet et al.’s mechanism is used to simulate the ignition of kerosene with calculations agreeing well with the experimental data. The sensitivity of reaction H+O2⇔OH+O, which shows the highest sensitivity to the ignition delay time, increases with an increase in temperature. The chain breaching reaction of CH3 with O2 accelerates the total reaction rate and the H-atom abstraction of n-decane controls the total reaction rate. The rate of production and instantaneous heat production indicate that two reactions, H+O2⇔OH+O and O+H2⇔OH+H, are the key reactions to the formation of OH radicals, as well as the main endothermic reaction. However, the reaction of R3 is the main heat release reaction during ignition. Flame structure analysis shows that initial pressure is increased slightly as CO and H2O will appear before main ignition.

Aerosol Shock Tube Designed for Ignition Delay Time Measurements of Low-Vapor-Pressure Fuels and Auto-Ignition Flow-Field Visualization

The ignition delay measurement of atomized kerosene air mixture in an aerosol shock tube

Study on Ignition Delay of Kerosene Aerosol in Shock Tube

Shock Tube Study on Auto-ignition Delay of Kerosene Aerosol and its Cracked Mixture

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

Shock Tube Study on Auto-Ignition Characteristics of Kerosene/air Mixtures

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

Ignition Delay Times of Kerosene (Jet-A)/Air Mixtures

Shock Tube Measurements of Jet and Rocket Fuels

Shock-Tube Study on Ethylcyclohexane Ignition

A method for shortening ignition delay of hydrocarbon fuel-air mixture

Shock tube measurements and kinetic investigation on the ignition delay times of methane/dimethyl ether mixtures

Non-uniform Ignition Behind a Reflected Shock and Its Influence on Ignition Delay Measured in a Shock Tube

Shock-tube Study of the Autoignition of N-Heptane/toluene/air Mixtures at Intermediate Temperatures and High Pressures

Shock Tube Measurements and Kinetic Study on Ignition Delay Times of Lean DME/n-Butane Blends at Elevated Pressures

Autoignition of Diesel/oxygen/nitrogen Mixture under Elevated Temperature in a Heated Shock Tube

To study on ignition characteristics of syngas mixtures by shock tube

Flow field visualization for ethylene/air auto-ignition at different pressures and temperatures in a rectangular shock tube

Shock Tube Study of Methylcyclohexane Ignition over a Wide Range of Pressure and Temperature

Measurement of Airblast Atomization of Low Temperature Kerosene with 25 Khz Digital Holography.

Shock-tube measurements of ignition delay times for the ethane/dimethyl ether blends