Abstract:The battery thermal management system (BTMS) is critical to electric vehicle (EV) safety and performance. In this paper, a novel cooling plate integrated with liquid microchannels and phase change material (PCM) is developed for use in BTMS, and its thermal performance at a high discharge rate of 5C is investigated. To improve temperature inhomogeneity, the non-metallic inlet shell is used to transport the coolant to the axial microchannels, which significantly reduces the temperature difference by 3.8 °C. Additionally, compared with I-shaped microchannels, the design of S-shaped microchannels increases the flow area for coolant and promotes the cooling effect, controlling the maximum temperature at 34.53 °C. Then, the parameters, including the number of microchannel layers, radial extension angle, inner diameter, and PCM thickness, are optimized by the multi-objective optimization, and its energy consumption is decreased to 9.61 × 10 -6 Wh and its energy density raised to 108.94 Wh∙kg −1 . Moreover, the cooling performance improves with the increase of the inlet velocity, and a balance between cooling performance and energy consumption is achieved when the inlet velocity is 0.06 m∙s −1 . Cross-convectional flow helps to enhance the temperature uniformity of the battery module further. The hybrid liquid cooling plate takes advantage of coupling active cooling and passive cooling; the energy consumption of BTMS is reduced by 46.3% without sacrificing the cooling capacity when delaying the beginning of active cooling after PCM passive cooling for 300 s. Furthermore, the PCM-embedded hybrid cooling plate slows the heat loss of batteries in cold environments, which can maintain their temperature above 20 °C after resting for 2 h at 0 °C. This work provides a reference for the hybrid cooling plate development of cylindrical batteries.

Performance improvement of a thermal management system for Lithium-ion power battery pack by the combination of phase change material and heat pipe

Design of battery thermal management system based on phase change material and heat pipe

Experimental and numerical investigations of lithium-ion battery thermal management using flat heat pipe and phase change material

Experimental investigation of the thermal performance of heat pipe assisted phase change material for battery thermal management system

Performance of a Combined Battery Thermal Management System with Dual-Layer Phase Change Materials and Air Cooling Technologies

Experimental comparison of the Li-ion battery thermal management systems using a new hybrid model of flat heat pipe coupled with phase change materials

A novel thermal management system combining phase change material with wavy cold plate for lithium-ion battery pack under high ambient temperature and rapid discharging

A hybrid battery thermal management system coupling with PCM and optimized thermoelectric cooling for high-rate discharge condition

Experimental and numerical study on the cooling performance of heat pipe assisted composite phase change material-based battery thermal management system

Simulation and Optimization of Lithium-Ion Battery Thermal Management System Integrating Composite Phase Change Material, Flat Heat Pipe and Liquid Cooling

Hybrid battery thermal management by coupling fin intensified phase change material with air cooling

Numerical simulation of hybrid battery thermal management system combining of thermoelectric cooler and phase change material

Thermal performance and structural optimization of a hybrid thermal management system based on MHPA/PCM/liquid cooling for lithium-ion battery

Study of a novel thermal management system using double-layer liquid-cooled plate-coupled PCM under high-rate discharge

Parameter optimization and sensitivity analysis of a Lithium-ion battery thermal management system integrated with composite phase change material

A hybrid thermal management system with liquid cooling and composite phase change materials containing various expanded graphite contents for cylindrical lithium-ion batteries

Numerical analysis of lithium-ion battery thermal management system using phase change material assisted by liquid cooling method

Thermal performance of a hybrid cooling plate integrated with microchannels and PCM

Passive and hybrid battery thermal management system by cooling flow control, employing nano-PCM, fins, and metal foam

Experimental investigation on hybrid cooled lithium‐ion battery pack with 3S4P cell configuration using OM 48 as phase change material and heat pipe

Thermal management characteristics of a novel cylindrical lithium-ion battery module using liquid cooling, phase change materials, and heat pipes