Abstract:To challenge the continuous operation performance of high energy density lithium-ion batteries at different ambient temperatures. A battery thermal management system combining Multi-stage tesla valve liquid cooling and Phase change material (MP) is proposed. After verification of the accuracy of the thermal model based on experimental measurements, numerical studies are performed at the end of 2C rate discharge. In addition, based on general full factorial design method, Kriging approximation model is used to construct complex nonlinear hybrid model between the spacing between batteries, the number of MSTV channels, coolant velocity and the performance of MP (pressure drop, standard deviation of surface temperature, and maximum temperature). At the same time, to avoid falling into local solutions, the adaptive simulated annealing (ASA) global search algorithm is integrated to optimize high-dimensionality multi-objective structural settings. The simulation results show that the designed MP-BTMS is connected with water/ethanol coolant and the inlet velocity is 0.193 m/s, the maximum temperature, standard deviation of surface temperature and pressure drop of the battery pack at 33.12 °C, 1.50 °C and 647.8 Pa, respectively. Finally, the optimised MP is used in continuous depth discharge conditions, as well as a range of simulation tests. The superiority of the optimum battery thermal management system in different application scenarios (liquid cooling/heating) is also verified. The cooling performance indicates that the use of MP reduces the total energy consumption required for coolant circulation by 79.9% compared to conventional BTMS. Moreover, it is found that at ambient temperature ( Tamb =-10 °C), the use of MP can keep the battery module warm twice as long compared to conventional BTMS. This means that MP can significantly delay the temperature drop during cold stops of EVs, thus reducing the energy required for active battery heating after short-term parking.

Thermal performance and structural optimization of a hybrid thermal management system based on MHPA/PCM/liquid cooling for lithium-ion battery

Compact Liquid Cooling Strategy with Phase Change Materials for Li-ion Batteries Optimized Using Response Surface Methodology

Structural optimization of light-weight battery module based on hybrid liquid cooling with high latent heat PCM

Optimization of the Heat Dissipation Performance of a Lithium-Ion Battery Thermal Management System with CPCM/Liquid Cooling

Novel concept design of low energy hybrid battery thermal management system using PCM and multistage Tesla valve liquid cooling

Performance of a Combined Battery Thermal Management System with Dual-Layer Phase Change Materials and Air Cooling Technologies

Optimization of Thermal Management System for Li-ion Batteries Using Phase Change Material

Simulation and Optimization of Lithium-Ion Battery Thermal Management System Integrating Composite Phase Change Material, Flat Heat Pipe and Liquid Cooling

Numerical analysis of lithium-ion battery thermal management system using phase change material assisted by liquid cooling method

Design and optimization of a hybrid cooling configuration combining PCM and liquid cooling for Li-ion battery using data-based response surface approximation model

A Compact Hybrid Battery Thermal Management System for Enhanced Cooling

Design and performance of a compact lightweight hybrid thermal management system using phase change material and liquid cooling with a honeycomb-like structure for prismatic lithium-ion batteries

Thermal performance of a hybrid cooling plate integrated with microchannels and PCM

A hybrid thermal management system with liquid cooling and composite phase change materials containing various expanded graphite contents for cylindrical lithium-ion batteries

A hybrid battery thermal management system coupling with PCM and optimized thermoelectric cooling for high-rate discharge condition

Parameter optimization and sensitivity analysis of a Lithium-ion battery thermal management system integrated with composite phase change material

Coupling Optimization of Protruding Fin and PCM in Hybrid Cooling System and Cycle Strategy Matching for Lithium-Ion Battery Thermal Management

Numerical Optimization for a Phase Change Material Based Lithium-Ion Battery Thermal Management System

Performance improvement of a thermal management system for Lithium-ion power battery pack by the combination of phase change material and heat pipe

Thermal Management Evaluation of Li-ion Battery Employing Multiple Phase Change Materials Integrated Thin Heat Sinks for Hybrid Electric Vehicles

A numerical study on a hybrid battery thermal management system based on PCM and wavy microchannel liquid cooling