Abstract:Battery thermal management systems play a significant role in the safety, performance, and maintenance of electric vehicles. This paper proposes a new hybrid cooling system incorporated with phase change material (PCM) and liquid cooling to achieve high performance and safety for the pack of prismatic batteries. Each four battery cells are grouped as a module and placed between vertically orientated mini-channel cold plates. PCM plates are also placed horizontally between the battery cells. This new design is simple enough to be implemented easily in common cooling systems and could provide parallel cooling of the active and passive methods with subsequent improvement in thermal performance and system safety. Three-dimensional numerical simulations are validated against previous empirical and numerical works. The thermal performance, power consumption, and safety of the hybrid cooling systems are investigated in a variety of battery discharge rates and mini-channel inlet velocities using different numbers of PCM plates. Also, the system performance is tested in a real driving cycle. This new design could notably improve the battery thermal management characteristics. The maximum battery temperatures in the hybrid system with three PCM plates at 2C and 3C discharge rates were 5.6 K and 16.2 K lower than those without PCM plates. Besides, adding three PCM plates reduced the temperature difference by up to 33 % at 3C discharge rate. Another key finding was that at 3C discharge rate, by simultaneously utilizing three PCM plates and decreasing the fluid inlet velocity, the power consumption per battery cell is reduced by 68 % (from 1.187 mW to 0.0375 mW). Furthermore, considering the PCM plates as the emergency backup, the time to reach the critical temperature increased by 38 % and 105 % in the systems with 1 and 3 PCM plates, respectively. Testing in a real driving cycle reveals the superiority of the hybrid system over the active cooling method by peak shaving of the thermal loads and reducing thermal fluctuations and maximum temperature. This novel design for battery thermal management could provide high performance for batteries and reduce fabrication and maintenance costs.

Numerical analysis of lithium-ion battery thermal management system using phase change material assisted by liquid cooling method

Electrochemical–Thermal Evaluation of an Integrated Thermal Management System for Lithium‐Ion Battery Modules

Liquid Cooling with Phase Change Materials for Cylindrical Li-ion Batteries: an Experimental and Numerical Study

A novel thermal management system combining phase change material with wavy cold plate for lithium-ion battery pack under high ambient temperature and rapid discharging

Numerical study of combined air and phase change cooling for lithium-ion battery during dynamic cycles

Design and performance of a compact lightweight hybrid thermal management system using phase change material and liquid cooling with a honeycomb-like structure for prismatic lithium-ion batteries

Compact Liquid Cooling Strategy with Phase Change Materials for Li-ion Batteries Optimized Using Response Surface Methodology

Numerical investigation on thermal management system for lithium ion battery using phase change material

Thermal management scheme and optimization of cylindrical lithium-ion battery pack based on air cooling and liquid cooling

Design and optimization of a hybrid cooling configuration combining PCM and liquid cooling for Li-ion battery using data-based response surface approximation model

Numerical simulation of hybrid battery thermal management system combining of thermoelectric cooler and phase change material

Thermal performance and structural optimization of a hybrid thermal management system based on MHPA/PCM/liquid cooling for lithium-ion battery

Experimental and numerical study of lithium-ion battery thermal management system using composite phase change material and liquid cooling

A hybrid thermal management system with liquid cooling and composite phase change materials containing various expanded graphite contents for cylindrical lithium-ion batteries

Low-cost numerical lumped modelling of lithium-ion battery pack with phase change material and liquid cooling thermal management system

Numerical study of thermal management of pouch lithium-ion battery based on composite liquid-cooled phase change materials with honeycomb structure

An improved hybrid thermal management system for prismatic Li-ion batteries integrated with mini-channel and phase change materials

Numerical Investigation of the Thermal Performance of a Hybrid Phase Change Material and Forced Air Cooling System for a Three-Cell Lithium-Ion Battery Module

Hybrid cooling-based lithium-ion battery thermal management for electric vehicles

A numerical study on a hybrid battery thermal management system based on PCM and wavy microchannel liquid cooling

A Compact Hybrid Battery Thermal Management System for Enhanced Cooling