Experimental and numerical investigations of lithium-ion battery thermal management using flat heat pipe and phase change material

Chengzhi Hu,Hongyang Li,Ye Wang,Xianfeng Hu,Dawei Tang

DOI: https://doi.org/10.1016/j.est.2022.105743

IF: 9.4

2022-11-30

Journal of Energy Storage

Abstract:This study considers adding both the flat heat pipe (FHP) and phase change material (PCM) module to reinforce the lithium-ion battery thermal management (FHP-PCM-BTM) system, and it is compared with the system with only the FHP (FHP-assisted BTM system). Results show that the FHP-PCM-BTM system outperforms the FHP-assisted BTM system regardless of the discharge rate. It reduces the “cold start” behavior, which is harmful to the battery life. At the final of the discharging process with 3C, the maximum temperature of the FHP-assisted BTM system is 318.6 K, but it is 312.3 K of the FHP-PCM-BTM system. Meanwhile, the maximum temperature difference is reduced by 1.02 K. Throughout the cycling experiment, the maximum temperature of the FHP-PCM-BTM system is lower than 313.15 K, even with a discharge rate of 3C. The advantages of the FHP-PCM-BTM system are beneficial from the high thermal conductivity and large latent heat of the PCM module. This module, including copper boxes and PCM, plays a role of a giant heat sink to absorb sizeable heat from the battery pack, so the battery temperature is efficiently controlled. This study paves the way for achieving high-performance battery thermal management by simultaneously using heat pipe and PCM.

energy & fuels

What problem does this paper attempt to address?

The paper primarily focuses on addressing the thermal management issues of lithium-ion batteries in electric vehicle (EV) applications. Specifically, the research attempts to improve the battery thermal management system (BTM) by combining flat heat pipes (FHP) and phase change materials (PCM) to achieve more efficient and uniform thermal management.

### Main Issues:
1. **Improving Thermal Management Efficiency**: Traditional thermal management systems often fail to dissipate heat effectively at high discharge rates, leading to excessive battery temperatures, which in turn affect battery life and safety.
2. **Addressing the "Cold Start" Phenomenon**: At low discharge rates, the battery pack experiences significant temperature fluctuations known as the "cold start" phenomenon, which is detrimental to the normal operation of the battery.
3. **Optimizing Thermal Distribution**: Achieving a more uniform temperature distribution within the battery pack to avoid local overheating.

### Research Methods:
- **Experimental Part**: An experimental setup was built using simulated batteries and thermocouples to monitor temperature changes within the battery pack, and thermal management was conducted using flat heat pipes and PCM modules.
- **Numerical Simulation**: Computational fluid dynamics (CFD) methods were used to model and simulate the system, verifying the thermal management effects at different discharge rates.

### Research Findings:
- The results indicate that the FHP-PCM-BTM system outperforms the system using only FHP at various discharge rates.
- At a 3C discharge rate, the maximum temperature of the FHP-PCM-BTM system was 312.3 K, while the maximum temperature of the FHP-BTM system was 318.6 K.
- Throughout the entire cycle experiment, the maximum temperature of the FHP-PCM-BTM system remained below 313.15 K, ensuring the safe operation of the battery.

Through this research, the paper provides a new solution for the thermal management of high-performance lithium-ion batteries. Especially under high discharge rate conditions, the combination of FHP and PCM can significantly enhance thermal management performance.