Abstract:SUMMARY The effects of pore fluids on the elastic properties of sedimentary rocks can be broadly categorized into two mechanisms: variations in pore compressibility due to the physical properties of the fluids and alterations in the stiffness of the rock frame resulting from rock–fluid interactions. Particularly, as rock–fluid interactions alter the stiffness of contacts between mineral grains, changes in the fluid properties around grain contacts can induce volumetric deformation of the rock as well as in variations of the associated elastic coefficients. Even though many previous studies have explored the influence of swelling of clay minerals, the relationships between changes in elastic moduli and deformation in rocks, which hardly contain swellable minerals, remain to date enigmatic. In this paper, to evaluate quantitatively these effects, drying rates, strains and ultrasonic velocities of small cylindrical Berea sandstone samples were measured as their water saturation was decreased by evaporative drying. The measurements clearly showed drying shrinkage and drastic increases in shear and compressional moduli for all the samples under an almost fully dried condition. Previous studies considered that the alteration in surface energy of grain minerals between wet and dry states affected the contact stiffness between them. Some of them used micromechanical model, uniting the Digby grain contact model with the effective medium theory, to interpret the changes in elastic moduli observed in the non-swellable sandstones during water adsorption on the grain surface. The conventional micromechanical model assumes that a mineral grain is a pure sphere and that the number of contacts between the grains is one. However, grains in a sedimentary rock are generally not purely spherical, and the contact surface is composed of several adhesive asperities. We therefore modified the conventional model by introducing the curvature radius and the number of asperities per contact surface. The modified model well reproduced the shear moduli under wet conditions using the strain and moduli measured under dry conditions. On the other hand, the predictions of the compressional moduli using the model were partially in agreement with the experimental results. Therefore, we attempted to qualitatively interpret the relationship by combining the model with the viscoelastic effect associated with wave-induced fluid flow. The deformation and changes in the elastic moduli of rocks resulting from multiple pore fluids within them can be better understood by the present combined model.

A model of plastic shrinkage

Is Early Drying Shrinkage Still Determined by the Mesopore Content? A Case Study of Cement Paste with Minerals

A Model for Predicting Evaporation from Fresh Concrete Surface During the Plastic Stage

Implementing capillary pressure control measures to prevent plastic shrinkage cracking in concrete

An implicit consideration of fluid flow in the calculation of drying shrinkage of porous materials: Case of saturated concrete in low humidity environment

Modeling Shrinkage of Portland Cement Paste

A plastic shrinkage cracking risk model for 3D printed concrete exposed to different environments

Shrinkage stress evolution during photopolymerization: theory and experiments

A refined deviatoric hardening plastic model for sand

Micromechanical Modeling on Autogenous and Drying Shrinkages of Concrete

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

Analysis of Vapor Pressure and Void Volume Fraction Evolution in Porous Polymers: A Micromechanics Approach

Shrinkage And Interior Humidity Of Concrete Under Dry-Wet Cycles

Shrinkage properties of porous materials during drying: a review

Evaluation of drying shrinkage effects on the elastic properties of porous sandstones using a modified micromechanical model

Influences of Fibers on Drying Shrinkage of Fiber-Reinforced Cementitious Composite

Shrinkage design model of concrete incorporating wet packing density

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Analysis of soil drying incorporating a constitutive model for curling

Physical modeling of the soil swelling curve vs. the shrinkage curve

Crack formation and self-closing in shrinkable, granular packings