Abstract:This paper focuses on the simulation of shrinkage stress in concrete structures under dry–wet environments. In the modeling, an integrative model for autogenous and drying shrinkage predictions of concrete under dry–wet cycles is introduced first. Second, a model taking both cement hydration and moisture diffusion into account synchronously is used to calculate the distribution of interior humidity in concrete. Using the above two models, the distributions of shrinkage strain and stress in concrete columns made by normal and high strength concrete respectively under dry–wet cycles are calculated. The model results show that shrinkage gradient along the radial direction of the column from the center to outer surface increases with age as the outer circumference suffers to dry. The maximum and minimum shrinkage occur at the outer surface and the center of the column, respectively, under drying condition. As wetting starts, the shrinkage strain decreases with increase of interior humidity. The closer to the wetting face, the higher the humidity and the lower the shrinkage strain, as well as the lower the shrinkage stress. As results of the dry–wet cycles acting on the outer circumference of the column, cyclic stress status is developed within the area close to the outer surface of the column. The depth of the influencing zone of dry–wet cyclic action is influenced by concrete strength and dry–wet regime. For low strength concrete, relatively deeper influencing zone is expected compared with that of high strength concrete. The models are verified by concrete-steel composite ring tests and a good agreement between model and test results is found.

A Model for Predicting Evaporation from Fresh Concrete Surface During the Plastic Stage

Investigation of early drying shrinkage of ultrahigh-performance concrete under windy conditions

Model of Chloride Penetration into Cracked Concrete Subject to Drying–wetting Cycles

Will Wind Always Boost Early‐age Shrinkage of Cement Paste?

Theoretical Modeling and Verification of Concrete Moisture Diffusion Surface Factor

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

A plastic shrinkage cracking risk model for 3D printed concrete exposed to different environments

Shrinkage And Interior Humidity Of Concrete Under Dry-Wet Cycles

An implicit consideration of fluid flow in the calculation of drying shrinkage of porous materials: Case of saturated concrete in low humidity environment

Modeling on Shrinkage Stress in Early-Age Concrete Pavements

A model of plastic shrinkage

MECHANISM AND MATHEMATIC MODELING OF CHLORIDE PERMEATION IN CONCRETE UNDER UNSATURATED STATE

MOISTURE CONDITIONS NEAR CONCRETE SURFACE: MODELLING AND APPROXIMATION

Experimental Study on Surface Cracking of Early-age Concrete

Calculation of shrinkage strain in early-age concrete structures---an example with concrete pavements

Modeling Moisture Transport at the Surface Layer of Fatigue-Damaged Concrete

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Water Transport Behavior of Concrete: Boundary Condition and Water Influential Depth

Micromechanical Modeling on Autogenous and Drying Shrinkages of Concrete

Shrinkage Stress in Concrete under Dry–wet Cycles: an Example with Concrete Column

Modelling of convection, diffusion and binding of chlorides in concrete during wetting-drying cycles