Abstract:From data collected by an online condition monitoring and fault diagnosis system, a higher pad temperature at the upper guide bearing in a pumped storage power generator unit installed in Guangdong province(GPSPS), China, was found. And also a relatively intensive shaft vibration occurred at the lower guide bearing. By calculating the Reynolds equation and viscosity-temperature equation of the lubricant, a curve between the pre-load coefficient and the increment of pad temperature is obtained, which shows that the larger, the pre-load coefficient, the bigger, the increment of pad temperature. For a practical unit in GPSPS, by employing Transfer matrix method and Wilson-theta method to analyze shaft vibration at different pre-load coefficients of the whole bearing or "pad pair" bearings, the results show that the larger the pre-load coefficient is, the smaller the vibration amplitude is, the shorter the time for vibration to become steady is. And an uneven pre-load coefficient of the "pad pair" bearings will cause shaft orbit from a circle to an ellipse whose long axes is at the direction of the "pad pair" with the lowest pre-load coefficient. Finally, reasons of higher pad temperature of the upper guide bearing and larger shaft vibration at the lower guide bearing are due to the inconsistent relation of bearing assembling clearance or pre-load coefficient of the upper and lower guide bearing, and also due to the too small, uneven pre-load coefficient of "pad pair" bearings. After a scheme for adjusting the bearing clearance is given, data measured show that the analysis and simulation methods are correct and the adjustment scheme to the assembling clearance of the upper and lower guide bearings is feasible and can be used to guide the field maintenance conveniently.

Dealing with problem of over-limit temperature of thrust bearing pad in scooptype water-turbine generator set at Yele Hydropower Plant

Influence Of Bearing Pre-Load Coefficient On Shaft Vibration And Pad Temperature In A Hydroturbine Generator Unit - A Case Study

Analysis and Treatment for the Tilting Pad Bearing Overheating Problem in Single Stage Overhang Centrifugal Compressor Unit

Bearing Pad Temperature Analysis Using Field Measurements and Simulation

Analysis and Treatment of Bearings Damage in 660MW Ultra-supercritical Turbine

A Review on the Large Tilting Pad Thrust Bearings in the Hydropower Units

Influence of Installation Deviation of Thrust Bearing on Oil Film Flow of 1000 MW Hydraulic Turbine Unit

Thermal Analysis on Bearing Body of Residual Heat Removal Pump in Nuclear Power Plant

The Influence of Installation Deviation on the Upper Guide Bearing Thermo-Hydrodynamic Characteristics of a 1000 MW Giant Hydropower Unit

The Analysis and the Handling Suggestion of High Temperature in 300MW Turbine

Analysis and Treatment of an Overheated Ablated Fault on the Pole Shoe Surface of a Large Tubular Hydro-Generator

Transient TEHD Analysis of a Thrust Bearing Based on Two-Way Fluid-Solid-Thermal Interaction

Experimental Study of Full-Size Tilting-Pad Bearings and Research of the Lubrication and Vibration Performance

Experimental Study on Pad Temperature and Film Thickness of Tilting-Pad Journal Bearings with an Elastic-Pivot Pad

Analysis on the Steam Temperature Deviation of the Vertical Water Wall and the Adjustment Plan of the Throttle Ring for an Ultra-supercritical Boiler

Hydrodynamic characteristic calculation for a 600 MW unit onceGthrough tower boiler

The Impact of Installation Deviation on the Lubricating Characteristics of a 1000 MW Giant Hydropower Unit’s Tilting-Pad Journal Bearing

Comprehensive Measures of Steadily Operating Hydroturbine Generator Units in Wanjiazhai Yellow River

Recent Progress in Service Induced Degradation of Turbine Blades of Aeroengine Due to Overheating

Vibration and noise of a high head pump turbine: analysis and improvement

Study on the thermoelastohydrodynamic performance of tilting-pad bearings for large-scale power units