Abstract:To facilitate the integration of greater amounts of renewable energy into the power grid, it is crucial to enhance the peak shaving capabilities of conventional thermal power units. This paper proposes a novel system that combines compressed steam energy storage with the Rankine cycle of a thermal power plant (referred to as the coupling system), and focuses on modeling a 200 MW thermal power unit. The performance evaluation and parameter selection of the coupling system are conducted through comprehensive energy analysis, exergy analysis , and economic analysis. The results indicate that the energy storage cycle in the coupled system can prevent boilers and turbines in the Rankine cycle from operating at extremely low loads during deep peak shaving. Specifically, when the boiler and steam turbine operate at 66.45 % of their design load, the external power of the coupling system can be reduced to 30 % of the rated power. This results in a reduction of coal consumption by 63.42 g/W * h compared to direct peak shaving of the original thermal power unit, and an improvement in exergy efficiency by 2.99 %. In this study, a 1300 m 3 energy storage circulating water storage tank capacity is used as an example, and it is found that the 200 MW unit can achieve continuous deep peak regulation operation for 8.58 h. The study also reveals that a 1 % increase in the isentropic efficiency of energy storage cycle compressors can lead to a reduction in coal consumption by 2.4 g/kW*h. Moreover, economic analysis suggests that maintaining a compressor efficiency of 86 %, utilizing 7 compression stages , and prioritizing the effectiveness of the heat exchanger are optimal for maximizing the system's revenue. These factors collectively result in a shorter payback period for the coupling system and an overall increase in total income.

ANALYSIS ON THE PERFORMANCE OF COMPOSITE HEAT-ACCUMULATION AND POWER-GENERATION TECHNOLOGY IN THERMAL POWER PLANT

Parameters analysis of 600 MW + 120 MW peak load unit by integrated generate technology

Performance Analysis of a Novel Hybrid Power Generation System Integrated Diesel Generator with Compressed Heat Energy Storage

Circulating Efficiency Test of Domestic 600MW Units and Their Performance Optimization Analysis

Analysis on Peak-shaving Energy Efficiency of Thermal Power Plant with High Temperature Thermal Energy Storage

A novel system for reducing power plant electricity consumption and enhancing deep peak-load capability

Evaluation of Combined Heat and Power Plants with Electricity Regulation

Configuration Method for Combined Heat and Power Plants with Flexible Electricity Regulation

Modeling and thermal economy analysis of the coupled system of compressed steam energy storage and Rankine cycle in thermal power plant

Experimental Study on Peak-shaving Ability of a 330MW Thermal Power Unit in Heating State

Design and Performance Analysis of Thermal Power Coupled Thermal Energy Storage with Integrated Steam Ejector

Analysis of heating load distribution and operation optimization for 350MW high back pressure double extraction series units

Analysis of Deep Peak Shaving Methods for Thermal Power Generation Units Based on the Improved Energy Consumption Framework

Design and feasibility verification of regenerative system of electric thermal storage boiler for peak shaving in summer in power plant

Thermodynamic analysis of the coal-fired combined heat and power units integrated with steam ejectors and thermal storage

Performance analysis of an efficient waste heat utilization system in an ultra-supercritical coal-fired power plant

Study on an on-line monitoring method for peak shaving capacity of thermal power unit

Design and Performance Analysis of Main Steam Coupled with Electric Heating Molten Salt Energy Storage System for Coal-Fired Power Plant

Comparison And Analysis For The Differential Heating Modes In The Large-Scale Chp System

Evaluation and incentive mechanism of peaking capability of hydroelectric/thermoelectric generators

Analysis and Evaluation of Multi-Energy Cascade Utilization System for Ultra-Supercritical Units