Parameter study of Hydrogen and dust explosion risk of Korean fusion demonstration reactor type using MELCOR

D. H. Lee,S. Moon,I. Bang

Abstract:The fusion reactor has researched as one of the future generation energy sources and can get a lot of energy from fusion reactions of deuterium and tritium in a vacuum. So far, safety analysis of nuclear fusion reactors has not progressed much, and it is needed to study that the accident analysis of nuclear fusion is different from fission reactors cases. Although the design of fusion demonstration reactor (DEMO) has not been determined perfectly, it is expected to be built on the basis of the ITER design. Analyzing accident scenarios that may cause radioactive release may contribute to a better DEMO design. Of these, leakage from the tritium in a vacuum vessel (VV) to the outside is considered most important in the accident analysis of the fusion reactor. Tritium inventories inside VV changes during operation and some of the tritium are burned from the plasma and some are kept inside and deposited, which in ITER undergoes periodic recovery and elimination of tritium. The reason for periodic evaluation and elimination of the inventory of tritium deposited inside the VV before reaching the safety limit is that there is a hydrogen/dust explosion issue. One of the major accident phenomena in the fusion reactor is the dust/hydrogen explosion. Hydrogen may catch on fire or explode if it is mixed with oxygen as a with a very low flammable points compared to other gases. The Fukushima Daiichi accident showed the importance of hydrogen explosions in safety analysis, which about 65 to 120 kg of hydrogen in the Unit1 could shock the containment due to the explosion [1]. Moreover, it should be noted that, as assessed by ITER RPrS (Preliminary safety report) [2], hydrogen explosions can act as a catalyst for dust explosions. Hydrogen explosion is induced when air enters a VV as a result of a broken tube causing the flow between the VV and the port cell. Pressure increase after the vacuum is lost due to the flow of hydrogen and dust isotopes to the VV, which forms a mixture of hydrogen and air, resulting in an explosion. As air enters the VV and the pressure increases, tritium and tungsten dust are generated, and the effects of hydrogen explosions can provide enough energy to cause dust explosions, leading to severe impacts and release of radioactive materials to buildings connected to the VV [3]. In this paper, hydrogen/dust explosion risk analysis were carried out in various accident scenarios of the hypothetical DEMO reactor. The system analysis code was used to analyze and evaluate the probability of hydrogen explosion through the Shapiro diagram and the amount of radioactive leakage in the event of an explosion.

Physics,Engineering,Environmental Science