Abstract:Water ingress into the primary circuit is generally recognized as one of the severe accidents with potential hazard to the modular high temperature gas-cooled reactor, which will cause a positive reactivity introduction with the increase of steam density in reactor core to enhance neutron slowing-down, also the chemical corrosion of graphite fuel elements and the damage of reflector structure material. The increase of the primary pressure may result in the opening of the safety valves, consequently leading the release of radioactive isotopes and flammable water gas. The research on water ingress transient is significant for the verification of inherent safety characteristics of high temperature gas-cooled reactor. The 200MWe high temperature gas-cooled reactor (HTR-PM), designed by the Institute of Nuclear and New Energy Technology of Tsinghua University, is exampled to be analyzed in this paper. The design basis accident (DBA) scenarios of double-ended guillotine break of single heat-exchange tube (steam generator heat-exchange tube rupture) are simulated by the thermal-hydraulic analysis code, and some key concerns which are relative to the amount of water into the reactor core during the blow-down transient are analyzed in detail. The results show that both of water mass and steam ratio of the fluid spouting from the broken heat-exchange tube are affected by break location, which will increase obviously with the broken location closing to the outlet of the heat-exchange tube. The double-ended guillotine rupture at the outlet of the heat-exchange will result more steam penetrates into the reactor core in the design basis accident of water ingress. The mass of water ingress will also be affected by the draining system. It is concluded that, with reasonable optimization on design to balance safety and economy, the total mass of water ingress into the primary circuit of reactor could be limited effectively to meet the safety requirements, and the pollution of radioactive isotopes releasing to the secondary circuit during the blow-down transient will be prevented.

The Cfd Analysis Of Hydrogen Behavior In Htr-Pm During The Water-Ingress Accident Caused By Double-Ended Guillotine Break Of Two Steam Generator Heating Tubes

Hydrogen behavior after water ingress accident of HTR PM

Water-Ingress Accident of the 250mw Pebble-Bed Modular High Temperature Gas-Cooled Reactor

Analysis on blow-down transient in water ingress accident of high temperature gas-cooled reactor

Analysis of Diffusion Process and Influence Factors in the Air Ingress Accident of the HTR-PM

Numerical Study Of The Air Ingress Accident Of The Htr-Pm And Possible Mitigation Measures

Air Ingress Analysis for Two Primary Loop Pipes Rupture of HTR-PM

Hydrogen risk analysis of a large pressurized water reactor using hydragon code

Discussion on Amount of Water Ingress Mass in Steam Generator Heat-Exchange Tube Rupture Accident of High-Temperature Gas-Cooled Reactor

Preliminary Analyses of Single Droplet Evaporation and Movement in the Steam Generator of HTR-PM

Study on Air Ingress of the 200 MWe Pebble-Bed Modular High Temperature Gas-Cooled Reactor

Assessments of Water Ingress Accidents in A Modular High-Temperature Gas-Cooled Reactor

A Research On Eliminating The Deposited Water After Water-Ingress Accident In Htr

Water-ingress analysis for the 200 MWe pebble-bed modular high temperature gas-cooled reactor

Safety analysis for hot gas duct vessel in HTR-PM

Analysis on hydrogen risk mitigation in severe accidents for Pressurized Heavy Water Reactor

Preliminary Analysis of Air Ingress Accident Mitigation Measure for HTR-PM

Characteristics of Droplet Formation During Spout Process of Water Ingress Accident

CFD investigating thermal-hydraulic characteristics and hydrogen generation from graphite–water reaction after SG tube rupture in HTR-10 reactor

CFD investigating the air ingress accident occurred in a HTGR_simulation of thermal-hydraulic characteristics

Hydrogen Safety Analysis of Ling'ao II NPP under LOFW+ATWS Accident