Abstract:In this paper, a novel field‐oriented control for three‐phase induction motors under a single‐phase open‐circuit fault is proposed. Compared to the standard field‐oriented control, the post‐fault control method designed in this paper only uses variable current PI controllers, and it includes a different d–q transformation. The validity of the proposed control strategy has been proven by several experiments. Based on the experimental results, the standard field‐oriented control achieves high torque and speed ripples and unbalanced current amplitude after the fault, while the proposed field‐oriented control demonstrates superior transient and steady‐state performances. In addition, compared with previous studies, the proposed controller in this paper can suppress the torque ripple. Summary This paper proposes open‐phase fault detection (FD) and tolerant control strategies for wye‐connected three‐phase induction machines (WCTPIMs). The FD mechanism is based on the comparison between predicted and actual values of stator currents, and the control approach is derived from the field‐oriented control (FOC). In the proposed fault‐tolerant control (FTC) method, an asymmetrical current transformation is used for stator current components, and the conventional symmetrical voltage transformation is employed for stator voltage components. It is shown that using these transformations, a modified FOC can be employed for the faulty WCTPIM. The suggested scheme is able to control WCTPIM drives under normal and single open‐phase fault (SOPF) modes with minor adjustments. Experimental results achieved from a laboratory prototype confirm the possibility and good performance of the proposed open‐phase FD and tolerant control for the WCTPIM under different operating conditions.

Single open‐phase fault detection and tolerant control for wye‐connected three‐phase induction machine drives

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Fault-Tolerant Control of Dual-Three-Phase PMSM under Open-Phase Fault Based on Two-Individual Current Control

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Speed sensorless fault-tolerant control of induction motor drives against current sensor fault

A Generalized Open-Circuit Fault-Tolerant Control Strategy for FOC and DTC of Five-Phase Fault-Tolerant Permanent-Magnet Motor

Optimized Fault-Tolerant Control of Dual Three-Phase PMSM Under Open-Switch Faults

Open-Phase Fault-Tolerant Direct Torque Control Technique for Five-Phase Induction Motor Drives

Modeling and control of 15-phase induction machine under one phase open circuit fault

Fault-tolerant Control of Multiphase Induction Machine Drives Based on Virtual Winding Method

Single-phase Open-circuit Fault-tolerant Control for a Dual Five-phase Permanent Magnet Motor with Multi-operational Modes

Optimized Current Trajectory Tracking Control of a Five-Phase Induction Machine under Asymmetrical Current Limits

A Modified FOC for FTC of Induction Motor Drives

Open-Circuit Fault-Tolerant Control of a Six-Phase Asymmetric Permanent Magnet Synchronous Motor Drive System