Abstract:This study shows that a eutectic Al–12Si alloy with controllable ultrafine microstructure and excellent mechanical properties can be achieved by using selective laser melting and subsequent solution heat treatment. This provides a novel and promising approach to the refinement of eutectic Al–Si alloys. Unlike Al–12Si alloys fabricated and refined by traditional methods, the as-fabricated Al–12Si in this study contains nano-sized spherical Si particles surrounding a supersaturated Al matrix. During solution heat treatment, precipitation and coalescence of the Si particles occur, which decreases the Si concentration in the matrix and sub-micron to micron-sized spherical particles embedded in an Al matrix form. The as-fabricated Al–12Si exhibits significantly better tensile properties than the traditionally produced counterparts; while the solution treated Al–12Si has an extremely high ductility of approximately 25%. Importantly, the mechanical properties of the Al–12Si can be tailored through controlling the precipitation and coalescence of the Si particles by varying the solution heat treatment time. A detailed transmission electron microscopy study was conducted to investigate this Al–12Si alloy with ultrafine eutectic microstructure. The excellent tensile properties have been attributed to the refined eutectic microstructure containing spherical Si particles. The formation of this unique microstructure is due to the super heating and an extremely high cooling rate during selective laser melting and the subsequent solution heat treatment, which enables Si to grow along its most stable plane {111}Si.

Morphological features of unmodified eutectic Si and morphological transformation after solution treatment

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

MORPHOLOGY OF EUTECTIC Si IN OVER-MODIFIED Al-Si EUTECTIC ALLOY

Growth Mechanism of Eutectic Si in Super-Gravity Solidified Al-Si Alloy During Annealing

Effect of modification and subsequent heat treatment on thermal and mechanical properties of near-eutectic Al-Si-Fe-Mg alloys

Al-Si nano clusters and short-range orders induced fibrous modified eutectic Si

Super-gravity field assisted homogeneous distribution of sub-micron eutectic Si in Al-Si alloy

Effect of solution heat treatment on the internal architecture and compressive strength of an AlMg4.7Si8 alloy

Microstructure Evolution of Modified Die-Cast AlSi10MnMg Alloy During Solution Treatment and Its Effect on Mechanical Properties

Segregation and Morphological Evolution of Si Phase during Electromagnetic Directional Solidification of Hypereutectic Al-Si Alloys

Morphologies of Si Phase and La-rich Phase in As-Cast Hypereutectic Al–Si–xLa Alloys

Solidification microstructure manipulation mechanism of hypoeutectic and hypereutectic Al-Si alloys controlled by trace in-situ nano-Fe 2 B and nano-Fe 3 Si

Modification of Eutectic Si in Al–Si Alloys with Eu Addition

Microstructure evolution of a novel low-silicon cast aluminum alloy modified with Mn and Cr during solution treatment

A Selective Laser Melting and Solution Heat Treatment Refined Al–12Si Alloy with a Controllable Ultrafine Eutectic Microstructure and 25% Tensile Ductility

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys

Dendritic Si growth morphologies in highly undercooled Al-Si alloys

Cellular Automaton Simulation and Experimental Validation of Eutectic Transformation During Solidification of Al-Si Alloys

A General Formulation of Eutectic Silicon Morphology and Processing History

Influence of Solution Treatment on Microstructure and Properties of In-Situ Mg_2Si/AZ91D Composites

New Method of Eutectic Silicon Modification in Cast Al–Si Alloys